Replacement RV Slide Out Power Gear Motor 522735

Question

Question:

Hello. I have a Powergear 522735 slideout motor from a 2004 Coachman cross country motorhome. Im trying to find the equiv replacement assembly. Can you help? Thanks!

asked by: Trevor D

0

Expert Reply:

I was able to cross reference the slide-out motor 522735 to the Replacement Gear and Motor Assembly for RV Slide Out part # LC386735 which is the correct replacement you need.

expert reply by: Jameson C

0

Answer 1

I verified with Lippert the correct replacement for your Power Gear slide-out motor 522735s is the following: - Replacement Gear and Motor Assembly for RV Slide Out - High Torque - Driver Side #LC386735

view full answer...

Answer 2

I called Lippert about your question on the Replacement Motor Assembly for Lippert RV Slide-Outs - Klauber A-300 Model, #LC157511. Their Tech Rep stated that the two smaller wires are to power the brake release/engage on the slide and should be…

view full answer...

Answer 3

To replace the ADTH 1RV-200 motor on your landing gear the Stromberg Carlson #LG-196308 will work perfectly. This motor is rated for 6,500 pounds like your existing unit. For a gear box replacement you'd want the #LG-179015.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

I spoke with Lippert and found that their replacement for your PowerGear Slide Out Motor 13-1086 is the Replacement Gear Motor Assembly for Lippert Slide-Out #LC386321.

view full answer...

Answer 6

Hi Robert; hopefully your Roadmaster tow bar is one that attaches to direct-connect base plates as opposed to crossbar base plates; for example the 8,000 lb Roadmaster Sterling would be optimal. Assuming that, here is what you need to flat tow your…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

Answer 11

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

view full answer...

Replacement RV Slide Out Power Gear Motor 522735

Product Page this Question was Asked From

Continue Researching