Air Bag Suspension Enhancement Recommendation for a 1993 Chevy 3500 Dually Lowered 4 Inches

Question

Question:

I am looking for a set of bags to help when i have loaded my 2002 Summerwind Truck camper. The vehicle has been lowered approx 4 inches. What set would you recommend for the rear only

asked by: Rick S

0

Expert Reply:

Since your 1993 Chevrolet 3500 Dually has been lowered approximately 4 inches, you will need to use the Air Lift SlamAir Air Helper Springs for Lowered Trucks, # AL59202. This kit was specifically designed to work with trucks that have been lowered from 2 to 6 inches.

I spoke with my contact at Air Lift to verify that this is the correct kit for your set up. Keep in mind that these air helper springs will not increase your trucks weight carrying capacity, but will help your suspension, improve ride quality and prevent bottoming out.

I have attached a product link for you to check out.

expert reply by: John H

0

Answer 1

The Air Lift SlamAir Air Helper Springs for Lowered Trucks part #AL59103 is confirmed to fit a 1996 Chevrolet C/K Series Pickup but is intended to be used on trucks that have been lowered 2"-4". The reason for the bag placement deals…

view full answer...

Answer 2

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 3

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 4

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 5

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 8

That spindle looks pretty well destroyed so best option is going to be to replace the axle. You are going to need to measure your current axles in a few places to get the correct one as we don't have access to what your numbers reference. You…

view full answer...

Answer 9

A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

A cover being installed on your spare tire would not prevent the Swagman Bike Rack part #S80501 from installing. The rack would still fit and work well. You might still compare the dimensions in the picture I attached with you spare tire so that you…

view full answer...

Answer 12

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Air Bag Suspension Enhancement Recommendation for a 1993 Chevy 3500 Dually Lowered 4 Inches

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching