Comparing Yakima Rack and Roll vs Malone Microsport XT for Carrying Two Kayaks

Question

Question:

I have two Hobie Outback kayaks. One is a 2018 model measuring 12’1”L x 33”W and weighing 81 lbs and 100 lbs fully outfitted. The second is a 2019 Model measuring 12’ 9” L x 34” W and weighing 85 lbs and 103 fully outfitted. I have been comparing Yakima Rack and Roll 78” vs Malone Microsport XT. Which do you recommend and what mounts do you recommend? Thanks.

asked by: Steve B

0

Expert Reply:

Both the Yakima Rack and Roll Trailer # Y08107 and Malone MicroSportXT Trailer # MPG460XT will work for you to carry your two Hobie kayaks, but I recommend the MicroSport XT because it is the better value of the two trailers.

The biggest difference between the two trailers is that the Rack and Roll has independent suspension, while the MicroSportXT has a leaf spring suspension. This is going to give the Rack and Roll a bit of a better ride, but that alone doesn't make up for the gap in price between the two. Everything the Yakima trailer can do, so can the Malone, and at a better price point, which is why I recommend the Malone MicroSportXT Trailer # MPG460XT.

For a carrier that will work I recommend two of the Malone MegaWing Fishing Kayak Carrier with Tie-Downs # MPG207.

With a 150 lb capacity, this is one of the few carriers with the capacity to haul your Hobie Outback kayaks, and will keep them completely secure on the square crossbars of the MicroSportXT Trailer # MPG460XT.

I have added links to video reviews of the trailers and carrier for you to check out as well.

expert reply by: Kyle S

0

Answer 1

We do have a hub that fits with your bearing numbers with the #AH15450ECOMP but the hub you mentioned does not fit

view full answer...

Answer 2

The Malone MicroSport trailers like you have use the bearing kit part #BK1-100 that you mentioned which comes with the correct seal size. Or for a replacement hub that comes pre-greased part #34822545BX. Then for a heavy duty and waterproof grease…

view full answer...

Answer 3

The Timbren Heavy-Duty Axle-Less Trailer Suspension #ASR2KHDS01 will be the only thing we carry to replace your square axle with the dimensions you have. This will replace your axle and leaf springs with a progressive spring and independent…

view full answer...

Answer 4

The Yakima Rack and Roll Trailer #Y08107 referenced in your question can be easily folded for storage in numerous positions, however the wheels themselves cannot fold flat. The wheels though can be easily removed along with folding the trailer to…

view full answer...

Answer 5

Yakima states that the Rack and Roll trailers like the part #Y08107 can be towed at posted speed limits as long as it's properly loaded and road conditions are good. So basically you can go the speed limit anywhere and be fine. I attached a…

view full answer...

Answer 6

I spoke with my contact at Yakima and found that the tires on the Rack and Roll trailer, #Y08106, are DOT rated. Trailer tires are tested to 65 miles per hour to meet DOT standards, so we cannot recommend towing the Rack and Roll trailer faster…

view full answer...

Answer 7

The Malone MicroSport Trailer #MPG461GS doesn't have a speed limitation. However the 12 inch tires should not be run above 65 miles per hour. You could add different tires with a higher speed rating such as #TT48012C which are rated for 81…

view full answer...

Answer 8

The tongue of the Yakima Rack and Roll Trailer, #Y08106, is 2 inches x 2 inches. We have this trailer on our lot, so I made a short video for you showing a few different dimensions of the trailer for you. If you are looking for a lightweight jack…

view full answer...

Answer 9

One of the many nice things about the Rack and Roll Trailer is that Yakima did a really good job of designing it so that it doesn't require a lot of maintenance. - Yakima recommends checking the wiring connections, beginning with the trailer…

view full answer...

Answer 10

Yakima does not recommend backing their Rack and Roll trailers like the #Y08107 you mentioned into water as the bearings aren't sealed and neither are the electrical connections. Your best option would be to back it right up to the waters edge…

view full answer...

Answer 11

If you are referring to the tail lights on the Yakima Rack and Roll Trailer like part #Y08107 then you must replace the entire assembly using the Replacement 4" LED Tail Light for Yakima Rack and Roll Trailer part #8880212. The tail lights are…

view full answer...

Answer 12

I don't see any reason the Yakima Rack and Roll Trailer part #Y08106 could not be used for a rooftop tent. The crossbars are adjustable, they are a standard size, and it has an adequate weight capacity. I think most people would like to be off…

view full answer...

Comparing Yakima Rack and Roll vs Malone Microsport XT for Carrying Two Kayaks

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching