Recommended A-Frame Power Jack for a Wells Cargo Enclosed Trailer
Question:
I am looking for a power jack for my wells cargo trailer EW1622
asked by: Dave T
Expert Reply:
I really like the Trailer Valet JXC Trailer Jack rated for 5,000 lbs # TV94FR. This is a newer type of jack that is actually operated by a power drill and I've seen it in action and it moves a lot faster than pretty much any other jack on the market, plus it comes in at a fraction of the cost.
The power drill isn't included but since Wells Cargo trailers are typically used for job sites I would imagine you're already carrying one anyways. When you don't have access to the drill or perhaps that battery needs to charge, you can use the included hand crank to operate the trailer.
If you're looking for more of a traditional power jack then I really like the Ultra-Fab 3.5K jacks as it performs really well and has received great feedback. This jack has 2 different ways to power it. For an on-board battery bank use part # UF38-944017, or if you wanted to operate it using the 12V power from the tow vehicle 7-Way socket use part # UF38-944037.
I have attached some videos of the Ultra-Fab jacks for you to check out.
Products Referenced in This Question
Ultra-Fab Electric A-Frame Jack - 18" Lift - 3,500 lbs
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Ultra-Fab Products
more information >
Ultra-Fab Electric A-Frame Jack w/ 7-Way Plug - 18" Lift - 3,500 lbs
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Trailer Valet JXC Trailer Jack w/ Footplate and Drill Powered Option - A-Frame - Sidewind - 5K
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Drill Powered
- Sidewind Jack
- 14 Inch Lift
- Bolt-On
- With Rectangle Foot
- Trailer Valet
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Big Truck Big RV
- Article: How to Measure for Trailer Hitch Drop
- Article: Using a Portable Generator on RV
- Article: Trailer Tire Sizing
- Q&A: Troubleshooting Factory Integrated Trailer Brake Controller on 2015 Chevrolet Silverado 3500
- Article: Trailer Maintenance Schedule
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Q&A: Comparing etrailer And Dexter 3,500lb 4 Drop Axles
- Q&A: Flexco Double Step Width Dimensions
- Q&A: Electric Trailer Brakes Grabbing Hard on Trailer
- Q&A: Low Profile Trailer Jack Recommendation for Better Tailgate Clearance
- Q&A: Trailer Hitch Receiver and Wiring Harness Recommendation for a 2020 Jeep Compass
- Q&A: How Do I Know If The MORyde Rubber Equalizers Will Fit On My Trailer