Correct Air Lift AirLift 1000 Air Helper Springs for a 2011 Chevy Avalanche

Question

Question:

Need some guidance to purchase air lift kit for 2011 Chevy Avalanche

asked by: Tracy

0

Expert Reply:

The correct Air Lift AirLift 1000 Air Helper Springs for Coil Springs for a 2011 Chevrolet Avalanche is part # AL60769. These airbags installs inside the factory rear coil springs and expand when aired up which works to limit the amount the coil springs can compress therefore limiting sag/squat. These are an excellent option which are easy to install and allow you to adjust the pressure for varying loads.

I have attached a sample install video below.

expert reply by: Conner L

0

Answer 1

A hitch extender or adapter, like the dual-receiver MT70070, cannot be used with weight distribution (WD) systems. As you note, use of ANY adapter has the unavoidable side-effect of cutting your hitch's capacity by 50-percent. An adapter would…

view full answer...

Answer 2

Using a hitch extender is safe as long as you stay within the limits specified of 50 percent of the hitch and vehicle load capacity, and 350 lb tongue weight capacity of part #HE06. The other option to provide additional clearance from your spare…

view full answer...

Answer 3

AirLift 1000 Air Helper Springs for Coil Springs #AL60769 are unfortunately not compatible with vehicles that have the factory installed auto-leveling option. However, if you carry/tow heavy loads regularly and experience sag, I recommend a quality…

view full answer...

Answer 4

I may have a solution for you, but it does not appear that there are any true air bag kits available for the 2009 Chevy Avalanche LTZ; from what I can find with some research it appears that most of these models have a shock and coil suspension and…

view full answer...

Answer 5

Both the Firestone #F4108 and Air Lift #AL60769 helper springs are confirmed to fit your Cadillac Escalade as long as you don't have the auto-leveling option. If your Caddy has the auto-leveling you'll need to go with the Firestone. There…

view full answer...

Answer 6

For air springs on your 2007 Chevy Avalanche, the Air Lift 1000 Air Helper Springs #AL60769 will be the most heavy duty option we currently have available. As the Chevy Avalanche in the 2007 model year has a max towing capacity of 7,200 pounds (when…

view full answer...

Answer 7

According to Air Lift, the #AL60769 is not compatible with vehicles equipped with the OEM auto-leveling suspension, i.e, factory air shocks and would therefore not work on your Avalanche. A Timbren system, like part #TGMRYS4 would be compatible with…

view full answer...

Answer 8

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 9

All you need is a ball mount that allows you to tow the trailer level. You can measure for the amount of rise needed to select the correct model. A ball mount with rise is needed when the trailer coupler is higher than the hitch receiver on the…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...