Trailer Wheel for Tire Size 18.5x8.50-8 with 4 Bolt Pattern

Question

Question:

Do you have rims for a 18.5x8.50-8 trailer tire? 4 on 4 lugs. Thank you.

asked by: Paul F

0

Expert Reply:

Yes, you'd need an 8 inch diameter wheel that is 7 inches wide with the 4 inch bolt pattern like part # AM20021 and you'd be set.

expert reply by: Jameson C

0

Answer 1

We have some 8 inch by 7 inch wheels, #AM20021, but none that are 7-1/2. You might be able to use the 8 x 7 inch wheels but you would need to determine if the tire size is compatible. Any given tire will fit a range of wheel widths so it is entirely…

view full answer...

Answer 2

For your 20x10-8 size tire, you can use an 8 inch x 7 inch wheel like the Americana #AM20021 if you have a 4 on 4 inch bolt pattern or #AM20026 if you have a 5 on 4-1/2 inch bolt pattern. Both wheels feature a nice white powder coat to resist…

view full answer...

Answer 3

The widest trailer wheel we offer for a 4 on 4" bolt pattern is the Steel Trailer Wheel part #AM20021 which measures 8" diameter x 7" wide and is designed to be used with a tire like the Loadstar K399 Bias Trailer Tire part #AM1HP26.

view full answer...

Answer 4

The 18.5x8.5-8 is actually an old tire size that is not used much anymore. The closest metric size to your existing tire would be 215/60-8. Your wheel most likely has a 5-on 4-1/4 inch bolt pattern (see link), you will want to make sure that the bolt…

view full answer...

Answer 5

That is definitely odd, but I would lean towards a hub/bearing issue. I didn't see you mention this step, but when installing the new hubs/bearings did you tighten the castle nut nice and tight to seat the bearings fully, and then loosen it up to…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 8

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 9

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 10

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Trailer Wheel for Tire Size 18.5x8.50-8 with 4 Bolt Pattern

Product Page this Question was Asked From

Continue Researching