Where to Plug in Hopkins Vehicle Wiring Harness on 2007 Jeep Liberty

Question

Question:

I dont have a towing package on my 2007 jeep liberty. Where is the plug in located?

asked by: Aaron O

0

Expert Reply:

You will plug the Hopkins Plug-In Simple Vehicle Wiring Harness # 42475 into your 2007 Jeep Liberty at the connectors which are behind the rear paneling on the passenger side.

I have added a cut out which is from the linked directions that shows exactly where you will find the connectors. I have also added a link to a video review for you to check out of the Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 42475.

expert reply by: Kyle S

0

click to enlarge

Answer 1

It sounds like you have a bad ground connection. If all ground connections are not making good contact to bare metal, when the brake pedal is pressed and the tail lights are on, the increased amperage draw will make this problem show up. You will…

view full answer...

Answer 2

If you look closely at Figure 1 of the instructions the hook should be to the right of the power port. You may have only a screw there. Remove the threshold panel first, Figure 2 part B. Then remove the screw and gently pull back the panel. The panel…

view full answer...

Answer 3

In order to flat-tow your 2005 Jeep Liberty with all four wheels on the ground you will need a base plate kit, tow bar, flat-tow wiring harness, safety cables, supplemental braking system, and possibly a high-low adapter. I have attached my…

view full answer...

Answer 4

We do have all the parts needed for you to flat tow your 2005 Jeep Liberty, and to make it easy to order I'll go ahead and list them out for you. As for shipping, we do indeed ship to Canada, and with in-stock products, they can be shipped right…

view full answer...

Answer 5

The correct Blue Ox base plate kit for your 2007 Jeep Liberty is the part #BX1122. Sounds like you already have a tow bar and all you need is wiring. Which for that I would recommend the Hopkins Tow Bar Wiring Kit part #HM56203. This will plug in…

view full answer...

Answer 6

For a 2006 Jeep Liberty, the OEM plug is located behind the paneling in the back of the vehicle on the passenger side. There is a grommet located in the floor to allow for the 4-flat connector to be run down by the trailer hitch. I have included a…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Where to Plug in Hopkins Vehicle Wiring Harness on 2007 Jeep Liberty

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching