Can Follow Leg of Landing Gear be Replaced with Lead Leg with Different Specs Than Current Lead Leg
Question:
I have a 2018 Keystone Hideout 308BHDS. The current single motor landing gear just isn’t sufficient, and I plan on adding a second motor/lead leg. My question is the motor in the LG-5 kit. It calls for the LG-142178 which is a 5500rpm motor. The existing motor is a LG-196308 which has a higher weight rating an slightly slower RPM of 5430. Would that make a big difference?
asked by: Scott T
Expert Reply:
I believe you are referring to the # LG-2 kit as it is the one with the 5,500 lb Motor # LG-142178 with it. Ultimately as long as you aren't exceeding the weight capacity of your landing gear and you have individual switches for each leg you should be just fine. Yes the RPMs are different, but they aren't relying on each other so you just have to pay attention when each leg makes contact with the ground.
If you'd rather go with a matching set I recommend the Reese Electric 5th Wheel Landing Gear Set # RP500708 because it has an 8K weight capacity (which should be more than enough for your needs), weld stops that have the standard 15-1/2" inside and 17-1/2" outside measurements, quick-release pins to make dropping the legs quicker, and a control panel with a dual switch so you have a really clean look after everything is installed.
Products Referenced in This Question
Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 5,500 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- Landing Gear
- 35 Inch Lift
- Weld-On
- 2 Jacks
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Landing Gear Recommendation for a 2002 Carriage Cameo Fifth Wheel Model F34CK3
- Q&A: Troubleshooting Landing Gear on Fuzion Toy Hauler That Will No Longer Lift Trailer
- Q&A: Replacement Follow Landing Gear Leg for 1998 Fleetwood Savanna 5th Wheel
- Q&A: Replacement Landing Gear For a 1999 Fleetwood Prowler 255 With Mounting Tabs Spread 19" Apart
- Q&A: Replacement Landing Gear for 2010 Open Range 5th-Wheel Trailer
- Q&A: Replacement Landing Gear Legs for a Forest River Wildcat Fifth Wheel
- Q&A: Where to Measure To Determine if Lippert Landing Gear Jack part # LG-1 Fits Trailer
- Article: Trailer Tire Sizing
- Article: My Trailer Hitch Doesn't Fit
- Article: Rooftop Cargo Carriers
- Article: Trailer Wiring Diagrams
- Article: How Much Solar Power Do I Need For My RV?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them