Dimensions of Polar Hinge # PLR2116

Question

Question:

How are the hinges measured?

asked by: Dan B

0

Expert Reply:

The overall length of the Polar Hinge # PLR2116 is 19-1/4 inch from one end to the other. It's 16 inches from the center of the hinge to the very end of the strap.

expert reply by: Jameson C

0

click to enlarge

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

For the clearance light part #AL91RB we have the grommet part #A91GB which is basically a hard rubber.

view full answer...

Answer 3

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 4

The Loadstar ST205/75D15 Bias Trailer Tire w/ 15" White Spoke Wheel part #AM3S640DX is a great choice. It offers the very common 5 on 4.5" wheel lug pattern. I do not have anything available in a 5 on 4.75" pattern available. I have…

view full answer...

Answer 5

From what I was able to determine the Tractor Supply trailer you have likely has a 2000-lbs axle on it, which has a 1-3/4" diameter axle. There isn't a specific over/under conversion kit for that size axle but you can use 2 of the spring…

view full answer...

Answer 6

Thank you for the pictures! I may have an option for you, but none of the hinges we offer have mounting brackets that are 5" tall.. The most likely option we have is the #PLR4040 which opens 270 degrees. The mounting bracket on the #PLR4040…

view full answer...

Answer 7

The T-Strap Hinge for Side and Rear Trailer Doors - 8" Long - Steel #PLR3408 will not be ideal for a 90 degree corner as you can see the purposeful bend at the hinge on the strap end of the hinge that would limit this. A better option for that…

view full answer...

Answer 8

The hole dimensions for the Over the Seal Strap Hinge are as follows. From the center of the hinge to the holes going down the shaft is 3-1/2", 9", and 14-1/2" respectively. So the measurement you're looking for is about 3 inches…

view full answer...

Dimensions of Polar Hinge # PLR2116

Product Page this Question was Asked From

Continue Researching