Installation of Pro Series Hitch Cargo Carrier # PS1040100 on 2012 Jeep Wrangler Unlimited
Question:
I have a 2012 Jeep Wranger with a stock spare tire. Im concerned that this rack elevates above the hitch and I wonder if I can install that main bar upside down so that the rack sits below the hitch rather than above. I am ok with drilling and taping new holes, I just want to know what your thoughts are. I certainly dont have an issue with ground clearance on the Wrangler. This looks like exactly the solution I need. Also, are any of the connections on the main rack welded or is everything bolt-together?
asked by: Rick
Expert Reply:
Since the capacity of the Pro Series Hitch Cargo Carrier, part # PS1040100, is derived from the design and correct assembly of the cargo carrier, I cannot recommend to modify the assembly or installation in any way. When a part is modified it can reduce the integrity and safety of the cargo carrier, along with the weight capacity.
The shank on the cargo carrier measures 12 inches from the center of the hitch pin hole to the raised side of the platform and raises 4 inches for clearance at the rear of the carrier, for going through dips and entering steep drives. I am including a picture with the dimensions shown.
If you are worried about the cargo carrier interfering with the stock spare tire you can measure on your hitch from the center of the hitch pin hole back to the farthest edge of your spare tire, and up 4 inches. If that measurement is less than 12 inches you should not have any problems with the cargo carrier clearing the spare tire.
You might also want to look at a hitch cargo carrier that will have a straight shank instead of an elevated shank like the Curt Hitch Cargo Carrier, part # C18109.
Most of the cargo carrier manufacturers when designing the carrier will take into consideration of a spare tire on the back of a vehicle and allow adequate clearance.
I am including a link to a FAQ page on hitch mounted cargo carriers.
Products Referenced in This Question
19x59 Curt Cargo Carrier for 2" Hitches - Steel - Folding - 500 lbs
- Hitch Cargo Carrier
- Flat Carrier
- Folding Carrier
- 20 Inch Wide
- Heavy Duty
- Fits 2 Inch Hitch
- 60 Inch Long
- Class III
- Class IV
- Steel
- CURT
more information >
Product Page this Question was Asked From
32x48 Reese Solo Cargo Carrier for 2" Hitches - Steel - 400 lbs
- Hitch Cargo Carrier
- Flat Carrier
- Fixed Carrier
- 32 Inch Wide
- Standard Duty
- Fits 2 Inch Hitch
- 48 Inch Long
- Class III
- Class IV
- Steel
- Reese
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Comparison of the Fixed Aluminum and Folding Steel Cargo Carriers
- Shop: 19x59 Curt Cargo Carrier for 2" Hitches - Steel - Folding - 500 lbs
- Shop: Flint Hill Goods 22" x 49" Cargo Carrier - 2" Hitch
- Shop: Flint Hill Goods 22" x 49" Hitch Mounted Aluminum Cargo Carrier - 500 lbs
- Video: Review of etrailer Hitch Adapters - Hitch Reducer Sleeves - e33YR
- Search Results: heat shield
- Video: Flint Hill Goods Hitch Mounted Aluminum Cargo Carrier Review - 2023 Toyota Highlander
- Video: Flint Hill Goods Hitch Cargo Carrier Review - 2019 Honda CR-V FHG27ZR
- Video: Flint Hill Goods Hitch Cargo Carrier Review - 2022 Toyota RAV4 FHG59ZR
- Video: Flint Hill Goods Hitch Cargo Carrier Review - 2022 Toyota RAV4 FHG27ZR
- Video: Flint Hill Goods Hitch Cargo Carrier Review - 2022 Chevrolet Tahoe FHG27ZR
- Shop: Brophy Hitch Reducer and Extender - 2-1/2" to 2" Trailer Hitch - 7" Long
- Shop: B&W Hitch Receiver Reducer Sleeve - 2-1/2" to 2"
- Shop: Trailer Hitch Receiver Reducer Sleeves - 3" to 2-1/2" or 2"
- Shop: GSI Outdoors Camping Tea Kettle - Stainless Steel - 1 Liter
- Shop: Towing Mirrors
- Search Results: hitch extender
- Search Results: cargo carrier
- Search Results: cargo basket
- Search Results: 2 inch extension
- Search Results: hitch extenders
- Search Results: curt cargo carrier
- Q&A: Recommended Sewer Hose Storage For Hose That Wont Fit In Trailer Bumper
- Shop: Trailer Hitch
- Q&A: Fit And Compatibility Of Curt Cargo Bag # C18210
- Q&A: Recommendation For Carrying Champion Generator Behind a 2000 Coachmen Travel Trailer w/ 2" Receiver
- Q&A: Shank Clearance of Pro Series Solo Cargo Carrier # PS1040100
- Q&A: Cargo Carrier Deeper Than 25-1/2 Inches That Can be Used on RV With Bumper
- Q&A: Is There RV Cargo Carrier that Can Attach to Frame Instead of Bumper
- Q&A: Flint Hill Goods 30" x 50" Wheelchair Carrier - What Size Is The Main Bolt For The Shank?
on Hitch Cargo Carrier
