How Long is T-Handle Latch PLR5730 When Locked and Unlocked

Question

Question:

Links of the rods on the polar t-handle latch plr5730. You stated the length was shorter when locked but longer when unlocked. I have a contractor cap on my truck with identical t-handles unknown company and need to know if you were correct in your open and closed measurements to see if I can replace mine with these

asked by: Shawn

1

Helpful Expert Reply:

The measurements of the T-Handle Latch # PLR5730 you referred to are correct.

The assembly measures 97-3/4 inches long when it is locked, and measures 96 inches long when it is unlocked.

expert reply by: Kyle S

1

Answer 1

We have a number of striker latches available, like the Lippert Standard Baggage Door Latch Kit #LC317649. Your picture doesn't necessarily tell me what you need. If you wanted to provide some more context or provide alternate pictures I would be…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Yes, you are going to also need the Demco Autoslide Capture Plates for Trailair Rota-Flex Pin Boxes #DM6171 when using the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040 with your Road Armor pin box. For a suspension enhancement I…

view full answer...

Answer 4

Hello Tim. We can definitely set you up with a complete AC system with an Advent low profile unit. We currently do not offer these parts as a package, but you can purchase all of the exact same components separately. To answer your question, yes, the…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

Yes, the Curt Custom Fifth Wheel Installation Kit for Ford #C93WR will work just fine with the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040.

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

Thanks for reaching out, Steve! Both Air Lift LoadLifter 5000 kits, parts #AL47PD and #AL82WQ, fit a 2021 Ford F-150 4WD. The only difference is whether your truck has the CCD (Continuously Controlled Dampening)/Onboard Scales, or the PowerBoost…

view full answer...

Answer 12

Both of the kits you mentioned are a fit for your 2016 Ford F-150. The difference is that the part #TFR1504E has a 6,000 lb capacity and the part #TFRTT1504E has a 7,000 lb capacity. You would want to go with the lower rated spring as it will be a…

view full answer...

How Long is T-Handle Latch PLR5730 When Locked and Unlocked

Product Page this Question was Asked From

Continue Researching