How Does Monitor of Roadmaster InivisiBrake Wire Up
Question:
My question was referring to the red power wire from the Invisi-Brake (page 2 of instructions for RM8700) that gets connected to a battery/power source. The power source I am referring to is the blue wire from the P2 (see attached). Yes, the included monitor will be installed.
asked by: Thierry S
Expert Reply:
On the motorhome side of the InvisiBrake install part # RM-8700 you would not want to use any of the wiring of your P2 brake controller part # 90885. The LED display of the monitor gets grounded and then actually draws power from the brake switch circuit of the toad vehicle like what you see in the attached wiring diagram.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Tow Bar Braking Systems
- Brake Systems
- Pre-Set System
- One Time Set-Up
- Fixed System
- Power Assist Brake Compatible
- Air Brakes
- Hydraulic Brakes
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Placement of InvisiBrake Module on a 2019 Jeep Cherokee Latitude Plus
- Shop: Roadmaster InvisiBrake Flat Tow Brake System - Preset
- Shop: Vehicle Tow Bar Brake System
- Q&A: How To Connect Trailer Brake Controller To Cold Side Of Stoplight Switch In 2020 GMC Terrain
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Must-Have Flat Towing Components
- Q&A: Parts Needed to Flat Tow 2015 Chevy Malibu LS
- Article: Trailer Wiring Diagrams
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Availability of InvisiBrake Installation Video on 1998 Jeep Wrangler
- Article: Flat Tow Package for 2011-2013 Jeep Grand Cherokee
- Article: How to Choose a High-Low Adapter
- Q&A: Choosing Between the Brake Buddy Select 3 and the Blue Ox Patriot Supplemental Braking System
- Q&A: Comparing The Roadmaster Invisibrake And Demco Stay-IN-Play Duo Supplemental Braking Systems
- Q&A: Wiring Diagram And Orange Wire Connection for Roadmaster InvisiBrake Supplemental Braking System
Thierry S.
9/27/2019
My question was referring to the red power wire from the Invisi-Brake (page 2 of instructions for RM8700) that gets connected to a battery/power source. The power source I am referring to is the blue wire from the P2 (see attached). Yes, the included monitor will be installed.