Replacement Pitch Arm Assembly for Solera 69 Flat Awning Support Arm

Question

Question:

I need a part for my awning that looks to be a common part that breaks on the solera system. It is the arm that attaches between the wall of the unit and the solera main arm. Can this be purchased or am I stuck buying the entire arm assembly?

asked by: Nick

0

Expert Reply:

Thanks for the photos, and from that it looks to me like you are asking if just the pitch arm assembly is available, and if so, the answer is yes, it is the Replacement Pitch Arm Assembly for Solera 69" Standard Flat Awning Support Arm # LC375994.

This is just the pitch arm part of the entire arm assembly, the Solera 69" Standard Flat Awning Support Arm # LC281154 so you do need to be sure this is the arm assembly you do have, and if so the pitch arm I referenced is the correct replacement. The only thing to note is that you will need one of the Replacement Retaining Washer for Solera Pitch Arm Assembly # LC431583 as well for the installation.

I have added a link to a video review of the replacement pitch arm for you to take a look at.

expert reply by: Kyle S

0

click to enlarge

Answer 1

When you go to install the Replacement Pitch Arm part #LC375994 you'd need to go with three of the retaining washers #LC431583.

view full answer...

Answer 2

In order to find the correct replacement arms for your 2016 Shasta Oasis you're going to need to measure the overall length of current pitch arms. If that length is accurate, then you are going to need the, Replacement Pitch Arm for Solera…

view full answer...

Answer 3

I attached a picture I got from Lippert that has their install instructions and diagnosis page for the #LC375994 that you referenced.

view full answer...

Answer 4

While we don't have a way of knowing what awning you have, I can tell you how to choose the right replacement support arms, so long as your awning is a Solera awning. To do so, all you have to do is measure the length of the wall mount, which…

view full answer...

Answer 5

The total length of the Solera Replacement Pitch Arm, #LC67VR, is 33 inches. Keep in mind that this is a specific replacement part for a specific awning, the Solera XL 63" flat awning support arm. If you have a different brand awning, please let…

view full answer...

Answer 6

You can reuse your current pin when installing the new Solera Pitch Arm part #LC375994 but you will need new retaining washers with part #LC431583.

view full answer...

Answer 7

I took a look at what Lippert and ourselves offer as replacements for the Lippert Solera awning, and the outer cover for the arm that you mentioned is actually offered as a replacement part. Instead, to replace that piece, you're going to have to…

view full answer...

Answer 8

When in comes to replacing leaf springs on trailers we recommend that you replace them in pairs so you are using the same springs on each side of the axle. I attached a help article on trailer suspension leaf springs for you to check out as well.

view full answer...

Answer 9

It sounds like you might be looking for the Replacement Retaining Washers for Solera Pitch Arm Assembly - Qty 1 #LC431583, which are used to replace the retaining washers needed for your Solera pitch arm assembly.

view full answer...

Answer 10

The Replacement Pitch Arm Assembly #LC375994 is 31.5" long overall which matches the measurement that you have. The Replacement Retaining Washers #LC431583 are needed to complete reinstallation of the new pitch arm.

view full answer...