Does the Brophy Cable Camper Jacks Come With the Upright Posts

Question

Question:

Other company reviews for the same product say the poles were not included. Are they included if I buy from etrailer?

asked by: Edward A

1

Helpful Expert Reply:

Yes, I cannot speak for our competitors but I can assure you that the Brophy Cable Camper Jacks part # CJ41 do come with the upright poles and all of the other parts you will need to lift your truck bed camper on and off your truck. The components that you see in the attached photo are all included.

expert reply by: Conner L

1

click to enlarge

Answer 1

Thanks for the photo and that model of Happijac is nearing a quarter-century old as of this writing and there are no longer replacement parts available for it. The best option we can offer are new camper jacks, the Brophy Cable Camper Jacks and you…

view full answer...

Answer 2

You should not have a problem with the camper sliding out when you are using any of the Brophy Cable Camper Jacks. The jack is very stable because of the tripod base. That stability will make the jack very difficult to tip to the front or the back.…

view full answer...

Answer 3

If one set of the HappiJac Extender Brackets part #HJ54FR doesn't provide enough clearance Happijac has told us that you can use a second set to gain additional clearance.

view full answer...

Answer 4

If you're looking for just the L-bracket for your HappiJac Electric Truck Camper Jack System #LC736514-ELKIT then you'll need part #LC182492. The flat bracket can be swapped out with part #LC182494 and the swing brackets can be…

view full answer...

Answer 5

I contacted the Rep at Happijac to inquire on your question of the HappiJac Swing-Out Extender Bracket for Dual Wheel Chassis Truck Camper Jacks, #HJ54FR. His response was that yes, you can "stack" the extensions. There is however a…

view full answer...

Answer 6

Hello, thanks for reaching out! The Swing Out Extension Brackets for HappiJac Truck Camper Jack Systems #LC182496 will fit all HappiJac systems so it will work just fine with your 3000 model.

view full answer...

Answer 7

The Brophy Slide In Camper Tie-Downs #HSAB might be a fit for your 2011 Ford F-150 but you'll need to do a bit of measuring first and you'll likely need to trim out holes where the tie-downs would sit. You'll want to verify…

view full answer...

Answer 8

The best priced pair of camper jacks we offer is the part #CJ31. If you needed a total of 4 of these jacks you'd need to order a quantity of 2 of these.

view full answer...

Answer 9

We've got what you're looking for. The Curt Front Mount Hitch Receiver, part #C31028 mounts to the undersides of the frame members at the front of your Jeep so that the receiver opening is located under the front bumper, as you can…

view full answer...

Answer 10

You should be able to change the orientation of the Brophy Cable Camper Jacks #CJ74 so that the legs pointing towards the cab of your pickup and the other legs will sit under your pickup bed a little to help stabilize your camper. I have attached a…

view full answer...

Answer 11

Thanks for the photos and like you said, they are the Atwood jacks 86065, which are discontinued jacks. What that means is the best option we can offer are new, manual camper jacks, the Brophy Cable Camper Jacks. Based on my research, your 2014…

view full answer...

Answer 12

The Brophy Cable Camper Jacks - 57" Max Lift Height - 3,000 lbs - Qty 2 #CJ41 would require two sets of jacks to lift your 4,500 lb truck bed camper and that application will absolutely work. The issue is the dually rear axle will cause…

view full answer...

Does the Brophy Cable Camper Jacks Come With the Upright Posts

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching