Furrion Powersmart Power Inlet Replacement for Power Cord Conversion Kit With LED Light

Question

Question:

Can I just get a replacement lid with the light? 2018 Sunset trail. Super light. Furion receptacle

asked by: Fred W

0

Expert Reply:

We do have a replacement that will work for you, even though the lid alone is not available separately; however, the inlet of the Furrion RV Power Cord Conversion Kit 125V - 30 Amp is something you can get.

What you need is the Furrion 30 Amp Power Inlet - White - LED # 431861 which has the Powersmart LED indicator and is the same power inlet used in the kit so you do not have to purchase the entire kit, you can just get the inlet.

I have added a link to a video review of this inlet for you to check out as well.

expert reply by: Kyle S

0

Answer 1

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 4

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 5

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 6

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 7

If you already have brake drums you will not have to replace them unless they are damaged or became overheated and have discoloration on the inside armature surface where the magnet rides, grooves in the armature surface, or severe wear where the…

view full answer...

Answer 8

On Dexter 12" Nev-R-Adjust Electric Brake Assembly #23-458 the shoe pad thickness is 3/16 of an inch. Dexter says that you should replace the shoes if the material gets down to 1/16 of an inch thick or less.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The Trailer Hub and Drum Assembly part #AKHD-545-35-EZ-K would be an excellent replacement for a Tru-Ryde Hub/Drum RVD-H-545. Then for new brakes, I recommend the Hydraulic Trailer Brake Kit part #AKFBBRK-35.

view full answer...

Answer 11

Hi Charles, I recommend the High Pointe RV Convection Microwave - Black #HP99ZR or Stainless Steel #HP49ZR. These convection microwaves are 20-1/2" wide x 14-3/4" tall x 18-11/16" deep so you should be able to just squeeze it in. The…

view full answer...

Answer 12

For replacement Dexter manual adjust brake assemblies to replace your 36-19 you would want the part #23-27 for the right hand side and part #23-26 for the left hand side. These are manual adjust 10 by 2-1/4 inch Dexter brake assemblies that would…

view full answer...

Furrion Powersmart Power Inlet Replacement for Power Cord Conversion Kit With LED Light

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching