How to Determine Correct Access Door or Cable Hatch Size for Trailer

Question

Question:

I have a 2009 Forest River Rockwood Freedom 1640LTD pop up camper and need an outside access cover for the fridge propane/electric lighting and adjusting compartment. I can send photos if you provide an email address. Thanks.

asked by: Robert

0

Expert Reply:

In order to select the correct hatch cover for your 2009 Forest River camper you need to know your hatch cut out size, or you can use a universal option, and I'll go over the selection of options we have and you can use this to determine which access door you can use once you take the appropriate measurements.

The Valterra Electrical Cable Hatch for RVs - 8-1/2" Long x 8" Tall - White # A10-2151VP or Black # A10-2151BKVP will fit your camper if it has a 6-13/16" long x 6-3/8" tall hatch cutout.

The Valterra Locking Electrical Cable Hatch for RVs - 7-5/8" Long x 6-1/2" Tall - White # A10-2150VP or Black # A10-2150BKVP will fit your camper if it has a 5-7/8" long x 4-3/4" tall hatch cutout.

The other option is a universal fit, the Ultra-Fab Universal Access Door for Trailers and RVs - 5" x 5" Opening - Chrome # UF48-979010 or White # UF48-979009 which you can attach and will give you a 5" x 5" door opening. The frame overall is 8" wide x 7" tall.

I have added links to video reviews for you to check out as well.

expert reply by: Kyle S

0

Answer 1

I went out to the warehouse and measure the Ultra-Fab Locking Multi-Purpose Access Door for RVs #UF48-979010. It's going to require an opening approximately 6" wide by 6" tall due to the beveled in section that allows the door to sit…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 7

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

How to Determine Correct Access Door or Cable Hatch Size for Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching