Replacement Vent or Vent Parts for a 1968 Serro Scotty Trailer

Question

Question:

Is there a replacement lift for the original vents?

asked by: Janet R

0

Expert Reply:

Without knowing the exact model used in your vintage trailer, you will have to go by the size of the opening and the roof thickness to choose a replacement vent. The vents that we carry will fit in a 14-1/4 inch square cut out in the roof.

A vent like # V2092SP-28, includes a garnish that fits roofs 1-7/8 to 3 inches thick. Other garnishes for thicker roofs are available. I have included a link to a video review of this vent for you. The roof vent isntallation kit, # 344270KITW, is recommended.

It is possible that some of the replacement parts we carry could fit your vent, but the only way to know would be to test fit them.

expert reply by: Michael H

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 4

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 5

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

Answer 6

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 7

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 8

If you're talking about adding a fan to the Ventline Ventadome Trailer Roof Vent #V2110SP-24 then no, you wouldn't be able to add a fan and would need to purchase a vent that already includes a fan like the Ventline Ventadome Trailer Roof…

view full answer...

Answer 9

The Go Power Overlander Expansion Kit - 200 Watt Solar Panel item #34282182 has everything you need to connect to your existing Go Power Kit with the exception of extension cables. I have listed the lengths available below: 10' Go Power MC4…

view full answer...

Answer 10

Hi Christopher, There unfortunately isn't a guide to tell us the exact part numbers for the vents, skylights, etc. on your Passport. We offer a variety of plumbing vents and 12v fan vents but we unfortunately do not offer skylights. If you want…

view full answer...

Answer 11

Hi Robert, So there isn't one that can be used with a cordless drill (which would be an electric jack only) as all the electric A-frame jacks are all higher than the 12" to 14" you want. There is a manual crank jack you can use which I…

view full answer...

Replacement Vent or Vent Parts for a 1968 Serro Scotty Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching