Can the Signal Booster for the TireMinder Smart TPMS Be Mounted In a Battery Compartment

Question

Question:

Can TPMS-APP-6 booster be installed in the RV battery compartment? This would be an easy location since its under the entry stairs on my Thor Chateau 24FS RV.

asked by: Mike A

0

Expert Reply:

Yes, you can install the signal booster for the TireMinder Smart TPMS for RVs part # TPMS-APP-6 in your battery compartment. The only requirements for mounting the signal booster are in a protected area around the middle of vehicle which the battery compartment matches therefore this will be a suitable location for installation. Please note I highly recommend you keep extra batteries on hand, the Replacement CR1632 Batteries for TireMinder TPMS part # MRI-CR1632.

expert reply by: Conner L

0

Answer 1

I looked up the hose and the regulator you currently have, and found that the GHA7 hose uses an ACME Nut connector to the LP tank and a 1/4 inch male inverted flare that connects to the 3/8 to 1/4 adapter used on the regulator. We offer the…

view full answer...

Answer 2

According to our friends at TireMinder, the manufacturer of theTire Pressure Monitoring System, part #TPMS-APP-6, the maximum effective range between the monitor and the sensors is 30 feet.

view full answer...

Answer 3

The TireMinders are indeed going to be a significant upgrade over your current tire pressure monitoring system, but they are not going to be compatible with an OEM or other tire pre-existing monitoring systems so you will need to replace your…

view full answer...

Answer 4

We do have a potential option for you, however the GM TPMS system you have will not work with any of our systems since they are a closed system, meaning they operate off of their own system. With that being said, I recommend taking a look at the:…

view full answer...

Answer 5

Unfortunately the only way to get a TPMS system that's compatible with the on-board system of your 2020 GMC Sierra 3500 would be to purchase GM branded system directly from them. That being said, the TireMinder Smart TPMS for RVs - Signal…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...