Lift Kit for a 2007 Fleetwood/Coleman Rio Pop-Up Camper

Question

Question:

Will this lift my 2007 Fleetwood Rio pop-up camper? I am trying to lift the camper so it can accommodate bigger tires for off-road

asked by: Nicholas R

1

Helpful Expert Reply:

In order to find out which Dexter Trailer Springs Over-Under Conversion Kit is correct for your 2007 Fleetwood/Coleman Rio you need to measure your axle tube diameter. If it is 2-3/8" which is most likely then you will need part # K71-384-00 but if it is 3" then you will need part # K71-385-00. These kits will then raise the trailer equal to the diameter of the axle tube plus the height of the leaf spring stack.

expert reply by: Conner L

1

Answer 1

My research indicates that your Flagstaff 176ED used a 3500 lb axle with a leaf spring suspension. The #LC382741 riser kit is designed for a torsion axle, and wouldn't work with a leaf spring suspension. If your suspension is currently set up so…

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 6

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 7

For your 2018 Ram 2500 with the factory puck system the best 5th Wheel Hitch is the B&W OEM Companion. If you have the 8 foot bed then you will want the fixed 25K #BWRVK3600 and if you have the short 6-1/2 foot bed you will need the 20K Slider…

view full answer...

Answer 8

Remove the locknut from the cable housing assembly of the #34466N11AB96GMA. Feed the cable through the mounting bracket or hold in the wall of chassis. Feed the locknut back over the cable and fasten securely to the backside of the bracket or wall.…

view full answer...