Would Running Boards from 2017 Chevy Silverado Fit 2008 GMC Sierra

Question

Question:

Will stock running boards off of a 2017 Chevy Silverado fit in to a 2008 GMC Sierra? Thanks in advance .

asked by: Zachary P

0

Expert Reply:

There was a large enough generation change between those two trucks that a fit from one would not fit the other. The Westin set part # 23-1955 that you referenced does fit the 2008 GMC Sierra as long as it's a crew cab.

expert reply by: Jameson C

0

Answer 1

It depends on what running boards you are talking about. For instance, the Westin E-Series Round Nerf Bars - 3" - Black Powder Coated Steel #23-1955 will fit a 2008-2013 Silverado 1500 Crew Cab and a 2014 2500 or 3500 Crew Cab. Let me know…

view full answer...

Answer 2

The Westin E-Series Round Nerf Bars - 3" - Black Powder Coated Steel #23-1955 will fit a 2008 Crew Cab Silverado but will not fit an Extended Cab. The Extended Cab would need #23-1685.

view full answer...

Answer 3

For reference, the Westin E-Series Round Nerf Bars #23-1955 will fit a variety of Chevy and GMC trucks between 2001-2014-inlcuding your 2005 Chevy Silverado. Because of the changes in body styles and mounting points throughout the years, the nerf…

view full answer...

Answer 4

That would all depended on the aspect ratio of the 215 tire. For example, a ST205/75-14 tire has an overall diameter of 26.1" and width of 8.1". A ST215/75-14 tire has an overall diameter of 26.7" and width of…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 6

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…

view full answer...

Answer 8

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 9

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Would Running Boards from 2017 Chevy Silverado Fit 2008 GMC Sierra

Product Page this Question was Asked From

Continue Researching