Can Double RV Waste Valves # T81B Install with Gray Valve on Left

Question

Question:

The Item # T80 looks like mine, except my grey water is on the left and set back and the black water valve is on the right. Can these be flipped end to end and still work properly?? Help

asked by: Anita D

0

Expert Reply:

Yes, you can install the Double RV Waste Valves # T81B with either the gray valve or the black valve on the left or the right. It can match the exact orientation of the picture that you submitted.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Bristol Double RV Waste Valve #34466NDHR19AAA that you referenced does not have bayonet fittings for hoses to attach to like you are asking about. All of the fittings are designed to fit over sewer hose and permanently install with solvent like…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height adjustments so you'll be able to set the hitch height…

view full answer...

Answer 6

Most if not all trailer wiring harnesses/connectors use larger wires for the 12 volt and ground circuits compared to the other circuits (lights). The sockets themselves don't have an amperage rating so you will go by the draw of the things…

view full answer...

Answer 7

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 8

The problem is that the plastic piece that's in your old pipe is cemented in place with cement like part #A05-0303 and it's very permanent. You won't be able to chip it out so you'll have to replace that piece of pipe as well. If you…

view full answer...

Answer 9

The gate valve #34466N11AB96GMA should come apart without cutting the pipe once the bolts are removed. I can se that the flange is completely loose so the gasket must have gotten too hot and melted to both sides of the pipe fittings. You should be…

view full answer...

Answer 10

The gasket is the portion of the gate valve that's allowing waste water to leak through and not actually the gate. Both companies are using a rubber gasket that will eventually fail so it really comes down to the other features of the gate valve…

view full answer...

Answer 11

The only options that we currently have with a 90 degree elbow would be a T-Style Hook like the JR Products #37210625 or #37211775. This is obviously a bit of a design change versus a plunger style that plugs directly so it will take a bit of…

view full answer...

Answer 12

Both the Jensen JWM6A and the current model, part #JWM62A are classified as double-DIN head units, which will both use the same sized rough openings in a vehicle dash. The old #JWM6A and the current model #JWM62A both use the same pigtail, as you can…

view full answer...