Replacement Legs For 4-Point Lippert Components Ground Control 3.0 Electric Leveling System
Question:
Tryed all the things you said found out driving down the road the 2 Jacks broke off at the bolt that holds the screw point broke and the Jacks fell out and bent the s### out of them
asked by: Jim J
Expert Reply:
I do have an option for you but the inner jack leg is not replaceable therefore if these were bent then you will have no other option but to replace the entire jack leg. I have attached for you below the correct replacement jack legs for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC358590.
Replacement Lead Leg for Lippert Components Ground Control 3.0 Electric Leveling System part # LC305340
Replacement Right Rear Leg for Lippert Components Ground Control 3.0 Electric Leveling System part # LC344792
Replacement Left Rear Leg for Lippert Components Ground Control 3.0 Electric Leveling System part # LC305339
Replacement Snapper Pin for Lippert Ground Control 3.0 Electric Leveling System part # LC225598
If you can better explain the issue you were having with the Lippert Ground Control 3.0 Electric Leveling System prior to the accident then I may have some advice for you.
Products Referenced in This Question
Replacement 3/8" x 3" Snapper Pin for Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pins and Clips
- Lippert
more information >
Replacement 24-1/2" Left Rear Leg - Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Replacement Lead Leg for Lippert Components Ground Control 3.0 Electric Leveling System - Qty 1
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Replacement 24-1/2" Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Wiring Installation for 5th Wheel Landing Gear Switch
- Q&A: Wiring Diagram for 5th Wheel Trailer Landing Gear with Red, Black, White, and Green Wires
- Q&A: Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch
- Q&A: Which Lippert Ground Control 3.0 System Is Recommended for a 37' Fifth Wheel
- Q&A: Drawing Schematic of Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Control Panel and Circuit Board for LCI Electronic Leveling System
- Q&A: Should The Wheels Come Off The Ground When Leveling A Camper Or Trailer?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Level Your Fifth Wheel in 3 Simple Steps (Manual or Auto-Level)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review