How to Remove Pin That Connects Slide-Out Motor to Slide-Out Arm

Question

Question:

How does the coupler pin go in and get taken out?

asked by: Ron

0

Expert Reply:

To remove your older slide-out motor so you can replace it with something like part # LC386321 you will need to tap that small pin out which connects the shaft from the motor to your slide-out arm. This can be done with a hammer but you may need to use some lubricant like WD40 and a nail punch as well.

expert reply by: Jon G

0

click to enlarge

Answer 1

I spoke with Lippert and they said the part number should be 6 digits long and usually starts with a 5. Can you please check to make sure you have all the numbers listed?

view full answer...

Answer 2

I spoke with Lippert and found that their replacement for your PowerGear Slide Out Motor 13-1086 is the Replacement Gear Motor Assembly for Lippert Slide-Out #LC386321.

view full answer...

Answer 3

Yes, you do have the exact right replacement converter for your 45 amp Magnetek 6345, which is the option from Progressive Dynamics: - Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V I have added links below to…

view full answer...

Answer 4

To order the correct Solera replacement arm size, simply measure the length of the wall-mount extrusion from top to bottom. I've pointed this out using the photo you sent in as an example. Short styles will measure 61-1/2" and use part…

view full answer...

Answer 5

There are two replacement slide out motors available to replace your current 5078-025, one with a connector on the end of the wires and one without a connector on the end of the wires. If you do not have the connector then you will need the…

view full answer...

Answer 6

There are two replacement slide out motors for you, one with a connector on the end of the wires and one without a connector on the end of the wires. If you do not have the connector then you will need the Replacement Gear Motor Assembly for Lippert…

view full answer...

Answer 7

Unfortunately when the gear box breaks the only option is going to be replacement. You could try taking it to a engine repair shop, but you'd most likely end up spending much more than the motor is worth on replacement parts, if they're even…

view full answer...

Answer 8

The correct replacement for your Power Gear Slide-Out motor 521748 is the Replacement Gear Motor Assembly for Lippert Electric Slide-Out #LC386322. I have added a link to a video review for you as well.

view full answer...

Answer 9

The correct replacement slide out motor for your Fleetwood Prowler is the Replacement Gear Motor Assembly for Lippert Electric Slide-Out part #LC386322. The Power Gear Motor 521748 was replaced by the Power Gear Motor 523387 which was replaced by the…

view full answer...

Answer 10

If some of the internal components of your Power Gear motor 520229 are damaged then the only option is to replace the entire assembly with part #LC386321 as there are no replacement internal components.

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

How to Remove Pin That Connects Slide-Out Motor to Slide-Out Arm

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching