RV AC/DC Breker Panel and Charger Compatible with Lithium Batteries

Question

Question:

Will this work with Lithium ion batteries? Will be using a 200AH LiFe Blue.

asked by: Jeff H

0

Expert Reply:

Yes, the Progressive Dynamics RV Power Control Center # PD4560K18LS8 that you referenced can switch between lead acid and lithium batteries so it will work with the Life Po style battery you have which is a lithium.

expert reply by: Jameson C

0

Answer 1

The correct version is the one seen towards the top of the Go Power Solar Cable Entry Plate #34273841REVA page. Not the larger one at the bottom. Go Power recently changed the style to a smaller footprint with better injection molds. I have included…

view full answer...

Answer 2

I checked with Progressive Dynamics and the breakers for the Progressive Dynamics 4500 Series Inteli-Power Converter #PD4575K18LS8 are 50 amp main. This is also true of the other models of 4500 Series Converter, parts #PD4560K18LS8 and #PD4590K18LS8.…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 8

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

RV AC/DC Breker Panel and Charger Compatible with Lithium Batteries

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching