Would Pop & Lock Power Lock Conversion Kit for Truck Caps part # PAL9772 Fit ARE Cap

Question

Question:

Will this work with an ARE DCU cap on a 2011 Chevy Colorado?

asked by: Jesse

0

Expert Reply:

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps part # PAL9772 that you referenced does fit your ARE DCU camper shell on your 2011 Chevy Colorado.

expert reply by: Jameson C

0

Answer 1

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps part #PAL9772 that you referenced does fit your ARE Classic Canopy.

view full answer...

Answer 2

So, there are a few things to look at when considering purchasing a truck cap that can be used with the Pop & Lock Power Lock Conversion #PAL9772 , which can help you determine whether or not it will work with a particular cap. Since we don't…

view full answer...

Answer 3

As long as your A.R.E. CX series truck cap has a single handle and not the two "T" handles then the Pop & Lock Power Lock Conversion Kit #PAL9772 will work. If you do have the "T" handles you will want to go with the Kit…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

The Trimax Puck Lock for Trailer Door Hasps #TMX96RR cannot be keyed alike. While disappointing I'm sure, there is another option to consider, which is to order a quantity of two of the Trimax Puck Locks for Trailer Door Hasps #TMX73FR. The…

view full answer...

Would Pop & Lock Power Lock Conversion Kit for Truck Caps part # PAL9772 Fit ARE Cap

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching