Instructions for Replacing Switch of Lippert A-Frame Jack
Question:
How can I get access to the step-by-step instructions to replace the switch on the LCI 1817941 tongue jack? Are they included with the replacement switch?
asked by: Jack K
0
Expert Reply:
In order to replace the switch # LC226023 you will need to obtain a pick tool or very small flathead screwdriver and beging to pry the top or bottom of the switch out of the housing. Once this is done you can then remove the spade terminals and install them on the new switch. In order to install the new switch you just simply press it into place after replacing the wiring.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Hitch Extender For 2-1/2 Inch Hitch For Weight Distribution
- Q&A: Replacement For A-Frame Tongue Jack on Lippert Electric Ground Control TT
- Article: RV Pre-Departure Checklist
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement for an Atwood Water Heater GC6AA-9E
- Article: Trailer Jacks
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Most Popular Wheel Bearings
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Trailer Hitch Drop