Replacement Spring for Power Gear Jack on 1998 Bounder Fleetwood Motorhome

Question

Question:

I have a 1998 bounder Fleetwood motorhome 34ft with a 454block p30 chassis.rear spring broke.need to know if u can help me with the part number for this unit.it not the small spring its the bigger spring. Power gear spring level system

asked by: David G

1

Helpful Expert Reply:

Sounds like the replacement spring part # LC359434 is what you'd need but you can verify this by comparing your jack to the picture I attached. If the spring you need to replace looks like what's in the attached picture this is the correct replacement.

expert reply by: Jameson C

1

click to enlarge

Answer 1

As long as you have good enough access to the jack legs you can leave them installed on your trailer when swapping the springs part #LC359434. I'd recommend putting something under the foot when the spring is off. The top bolt that Conner…

view full answer...

Answer 2

Since you have a Power Gear RV jack the correct replacement spring kit is the part #LC359434 that you referenced.

view full answer...

Answer 3

I do have a way in order for you to flat tow your 2017 Jeep Renegade, however the only way this is possible according to the manufacturer is by using a tow dolly. Unfortunately, the Jeep Renegade is not compatible being flat towed with four wheels…

view full answer...

Answer 4

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Replacement Spring for Power Gear Jack on 1998 Bounder Fleetwood Motorhome

Product Page this Question was Asked From

Continue Researching