What Circuit Tester is Used in the Installation Video for the Peak Wireless Backup Camera

Question

Question:

I watched the installation video instruction and I must say it was well done. My question is what is that tool you used to check the live wire for reverse? Do you sell that tool? Thanks.

asked by: Miguel M

0

Expert Reply:

The circuit tester that our installer used to test the reverse light wire when installing the Peak backup camera is the Draw-Tite Circuit Tester, # PTW2993.

expert reply by: Robert G

0

Answer 1

The Dutton-Lainson Hand Winch part #DL15303 comes with a 9-1/2" long handle. The only available handle offered in a shorter length is the Replacement Handle for Dutton-Lainson Single Speed Hand Winch part #DL70305 which measures 7" long.

view full answer...

Answer 2

The 5-way flat trailer connector in-line circuit tester #20115 you referenced won't be needed. You would need to have a 12V power source and your jumper wire which will let you know if you have working trailer lights. The most common gauge…

view full answer...

Answer 3

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 4

Hey Dave, The Curt Custom Tail Light Wiring Kit for Towed Vehicles #C96JR would not be intertwined or interfere with the Blue Ox Patriot #BLU37TR. This wire harness is simply plugging into the motorhome and Gladiator tail lights to copy the light…

view full answer...

Answer 5

Your brake lights and turn signals for each side are on one circuit. The left side turn signal and brake light is generally the yellow wire going into your trailer connector. The first thing to do is check the fuses on your tow vehicle. Next, inspect…

view full answer...

Answer 6

The 4-way on your trailer is what's known as a wishbone connector like part #A35W42B. Two of the wires are the running light circuit which is a little easier to install since you can run one down each side of the trailer. This way you don't…

view full answer...

Answer 7

Since you are not getting the 12V power when your truck is running, you most likely don't have a fuse issue as you stated their isn't a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at the…

view full answer...

Answer 8

It sounds like you may have a loose wiring connection or a corrosion problem on the 7-way pin for the right turn/brake lights. This pin is the one at the 3-o-clock position as you're looking at the vehicle's 7-way; please refer to the linked…

view full answer...

Answer 9

Most trailer wiring problems are the result of a bad ground. What I would do is start with the connectors. Maker sure the connectors on both the trailer side and vehicle side are free of dirt and corrosion and that they are properly grounded. Next, I…

view full answer...

What Circuit Tester is Used in the Installation Video for the Peak Wireless Backup Camera

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching