Can Over-Under Conversion Kit be Used to Raise Height of Office Trailer
Question:
We have a 32’ office trailer that we replaced the hubs, brakes, tires and wheels. With the new wheels and tires there is only 3/4” of clearance from the underside of the trailer. Could we use an over/ under kit to remedy the situation?
asked by: Daniel
Expert Reply:
You can definitely use an over-under conversion kit to give you more clearance as 3/4" is not nearly enough. If you have a 2-3/8" axle then you need part # K71-384-00 but if you have a 3" axle you need part # K71-385-00. What an over-under kit will do is raise the height of your trailer equivalent to the size of the axle plus the height of the leaf spring stack. This should get you much closer to the recommended 4" of clearance.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions for the MORryde ALLTREK 4000 Suspension Kit
- Q&A: Double Eye Leaf Springs For Tandem Axle Trailer With 10,500LB Rating and 24" Length on Spring
- Q&A: Does MORryde ALLTREK 4000 Cushioned Equalizer Sit Taller to Offset for Additiona Suspension Movement
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Q&A: What Leaf Spring Width SHould be Used with Dexter Over Under Kit # K71-384-00
- Q&A: Would Dexter 3,500 lb Axle Made in 1999 Use Same Hubs as Current