Go Power Solar Charging System for Pre-Wired Trailer with Curved Roof

Question:

Will the GoPower overlander work on a slightly curved trailer roof? it is what was suggested by GoPower as my TT is prewired for that brand. Any other suggestions?

asked by: Michelle

Expert Reply:

Since you already confirmed with Go Power that their Overlander Solar Charging System # 34282181 is confirmed to work with the pre-wiring on your travel trailer I would not suggest something else instead. This complete system includes the 200-watt panel, controller and wiring and installation will be a lot easier than with another product that may not work with your factory pre-wiring.

Another excellent long-term benefit of this system is that is is expandable simply through addition of a second panel, part # 34282182. The controller than comes with the complete Overlander kit will handle the second panel. You'll just need a cable like 3-foot # 34274672 or 10-foot # 34276216. I also recommend the Adjustable Mount Kit # 34244034 which enables adjusting the panels' angle for maximizing their energy output.

You may care to check out the linked articles on RV solar installations.

expert reply by: Adam R

Bruce L.

5/21/2020

I just ordered the overlander solar kit. My rv is pre wired with #10 wire. When I run the wire from the controller to the batteries should I stay with #10 or go up to #8 ? The controller is going to be about 5ft from the batteries. Thank You .

Chris R.

5/25/2020

I think you'll be fine sticking with 10 gauge wiring for your setup, especially considering the relatively short distance you have between the controller and battery bank.