Thule TracRac Sliding Ladder Rack for 2015 Toyota Tundra CrewMax 5.5 ft Bed

Question

Question:

Would this Thule TracRac SR Sliding Truck Bed Ladder Rack work on the 2015 Toyota TundraCrewMax with a 5.5 Ft bed?

asked by: David S

0

Expert Reply:

We have a fit, but for your 2015 Toyota TundraCrewMax with a 5.5 Ft bed the TracRac SR Sliding Ladder Rack you mentioned is for the 6-1/2 foot long bed versions of the truck. Instead we have the part numbers # TH21784 and # TH43002XT and you'd be set with the correct version of this rack.

expert reply by: Jameson C

0

Answer 1

The Thule Hullavator part #TH898 takes up approximately 28.5 inches of cross bar space so you would need at least 57 inch bars, therefore the 65 inch bar you mentioned will work. Keep in mind that the Hullavator requires 4-8 inches of cross bar…

view full answer...

Answer 2

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 6

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 7

For your setup I recommend the TrackTowers for Yakima Crossbars and Platforms - Track Mount #Y52AV which includes everything you need to mount Yakima crossbars to your Retrax cover (unless you plan on using the Round or HD bars - then you'll need…

view full answer...

Answer 8

I have a Yakima crossbar setup that is compatible with the Retrax Pro XR Tonneau Cover on your 2021 Toyota Tacoma, however, the Yakima Bedrock is not compatible and the 60" crossbars would be too short anyways. I recommend going with the…

view full answer...

Answer 9

Yes, the Thule TracRac SR Sliding Truck Bed Ladder Rack part #TH43002XT-782 for 5-3/4' beds or part #TH43002XT-781 for 6-1/2' bed will work on a 2019 GMC Sierra 1500 with BAKFlip M4 Tonneau Cover.

view full answer...

Answer 10

We have ladder racks that are compatible with the BakFlip Revolver X4 tonneau cover you have on your 2017 Ford F-150 short bed. If you have a 6-1/2 foot bed you'd want the part #TH43002XT-501. If you had the 5-1/2 foot bed you'd instead want…

view full answer...

Thule TracRac Sliding Ladder Rack for 2015 Toyota Tundra CrewMax 5.5 ft Bed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching