Bracket Recommendation to Carry 4-Way Connector of Trailer Wiring Harness # C56333
Question:
Quick question do you have a mounting bracket so I may have a clean install for the flat 4 pole wire. Just asking for my preference I dont like the wire hanging. install on a 2010 Chrysler town and country
asked by: Keith
Helpful Expert Reply:
You can use the 4-way bracket part # 18144 to hold the 4-way connector of the Curt harness part # C56333. This would attach to the bottom of the rear bumper and would do a great job to hold the 4-way when not in use so that it's not dangling behind the vehicle. I attached a picture of this bracket installed in a similar way attached to a rear bumper.
Products Referenced in This Question
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Thule Hideaway Awning And Adapter For A Winnebago Solis 59P
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trostel 324-216-8 Replacement Grease Seal
- Q&A: Recommended Hitch and Wiring Harness for a 2017 Jeep Patriot
- Q&A: Transmission and Power Steering Coolers for 2015 Jeep Patriot
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Trailer Brake Drums For Dico 15638 With ST175/80R13 Wheels and Tires
- Q&A: Parts Needed to Install 7-Way on 2021 Subaru Outback Wagon
- Q&A: Difference Between Thule HideAway Awning 630001 and 491010
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Hitch Receiver Sizes
- Article: Double-Eye Trailer Suspension System Review
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)