Troubleshooting Trailer Running Light Circuit Not Functioning
Question:
All the lights but the parking lights are working. I have flashers, right and left blinkers, brake and backup lights, but no parking lights.
asked by: Paul
Expert Reply:
Try connecting a known working 12 volt power source to the brown wires of the Blazer LED Trailer Tail Light # C7493RTM that you referenced. This is the running light circuit. If the light does not come on then the assembly is the problem but if it does then you know it's the wiring that runs to the assemblies.
You should also verify that the white wire is connected to a solid ground too as that can sometimes cause lights not to work.
Product Page this Question was Asked From
Blazer LED Trailer Tail Light - Submersible - 6 Function - 7 Diodes - Red Lens - Passenger Side
- Trailer Lights
- Tail Lights
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 4-3/4L x 5-1/8W Inch
- Red
- Blazer
more information >
Continue Researching
- Q&A: Closest Metric Replacement Tire Size for 7.00-15 Tire on Livestock Trailer
- Q&A: Fixed Side Vs. Float Side for Replacement Standard Dual Rack Repair Kit Wall Slide-Out
- Q&A: Trailer Jacks Manufactured in the USA
- Q&A: Correct Tankless Water Heater Replacement for Atwood 6 Gallon 16" x 12"
- Q&A: Cannot Push Plunger Back In On Trailer Breakaway System
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: How to Install a Ventline Ventadome Roof Vent with 12 Inch Fan Powered Lift
- Q&A: Replacement for Kwikee Control Module 909513
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Trailer Jacks