Is the Rhino-Rack Sunseeker Awning Compatible with Yakima JetStream Crossbars

Question

Question:

Will this fit on Yakima jetstream crossbars?

asked by: Aaron I

0

Expert Reply:

Yes, the Rhino-Rack Sunseeker Awning # RR32133 comes with bolts that fit in the T-Slots on Yakima JetStream crossbars so they are compatible with each other.

I have attached a review video of this for you to check out as well as the installation instructions for you to reference.

expert reply by: Jon G

0

Answer 1

Since Rhino Rack doesn't offer a lock designed for the Batwing like the #RR33200 and the Thule you mentioned would not work the best option is a cable lock like the part #e98891 which you could wrap around the awning setup to secure it.

view full answer...

Answer 2

I have a solution for you, and in some complete roof rack kits the Yakima Jetstream crossbars #Y00425 will come with the Adapter and Seat for Yakima JetStream Crossbars - Qty 1 #8880637. However, if you're adding crossbars to existing towers…

view full answer...

Answer 3

The Rhino Rack Sunseeker Awning #RR32133 can mount to your crossbars but not directly to the basket. The brackets that come with the awning should fit on your bars even with the basket on there too. You may need to shift the basket to one side to…

view full answer...

Answer 4

The Rhino-Rack Sunseeker Awning, part #RR32133, mounts to either the Rhino-Rack Pioneer Platform or the T-slots of other crossbars. Your 2017 Honda CR-V with factory crossbars do not have T-slots, so your only option is to attach a Pioneer Platform.…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 12

Both the Rhino-Rack Vortex Aero and Thule WingBar roof rack systems have very nice features and would work well for your 2014 Hyundai Santa Fe. Both systems are designed to work on vehicles that have the flush mounted rail system. As far as the…

view full answer...