Why Would My Hopkins Break Away Switch Blink
Question:
Why would my break away switch light blink?
asked by: Jack G
Expert Reply:
I contacted Hopkins and the only reason that the LED light on the Hopkins break away switch part # HM20060 would blink is because of a partial connection somewhere on the setup. The light should not illuminate if you have a proper connection at the pin and wiring.
If you wiggle the pin and the light blinks then the pin may not be properly seated. You want to push the pin in and make sure it is completely inside the box.
If the pin is properly seated, you want to check the wiring specifically the white ground wire. If you spliced the ground wire from the breakaway to the main trailer ground wire make sure there they are connected. If you are using a junction box with a ring terminal you want to make sure the ground ring terminal is seated on the stud.
Another reason the light may blink is the blue and black wires are reversed. The blue wire splices into the electric brake wire and the black wire splices into the 12V power wire. I have attached an installation video for your reference.
Product Page this Question was Asked From
Hopkins Pull to Test Breakaway Switch with 48" Long Cable
- Accessories and Parts
- Trailer Breakaway Kit
- Switches
- Hopkins
more information >
Continue Researching
- Search Results: tjd~7000~ft
- Shop: etrailer Electric Trailer Brakes w/ Dust Shields - Self-Adjusting - 12-1/4" - Left/Right - 8K
- Q&A: Weak Voltage At Brake Output Circuit On 7-Way Plug
- Shop: Dexter Electric Trailer Brake Assembly - 12-1/4" - Left Hand - 8,000 lbs
- Shop: Dexter Electric Trailer Brake Assembly - 12-1/4" - Left Hand - 7,200 lbs
- Q&A: Installation Instructions For Hopkins Engager Trailer BreakAway Kit
- Shop: Brake Controller
- Article: Testing Trailer Brake Magnets for Proper Function
- Shop: Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 8,000 lbs
- Shop: 6-Leaf Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long
- Shop: Dometic 310 Part-Timer RV Toilet - Standard Height - Round Bowl - Slow Close Lid - Tan Ceramic
- Q&A: Troubleshooting Voltage Drop to Trailer Brake Assemblies
- Shop: Curt Echo In-Line Bluetooth Brake Controller w/ OneControl App - 1 to 4 Axles - Proportional
- Shop: Suspension Enhancement
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Search Results: brake shoe
- Shop: Trailer Hitch
- Video: Kodiak Synthetic Bearing Oil for Oil Bath Hubs Review
- Q&A: Troubleshooting Amazon Trailer Leaf Springs Failing Within 100 Miles Of Use
- Search Results: 1824200100
- Video: Hopkins LED Breakaway Switch Installation
- Q&A: Can a 14125A Trailer Wheel Bearing Replace a 15123 Bearing
- Q&A: Will Upgrading Leaf Springs Increase Trailer Weight Capacity
- Q&A: What Are the Torque Specs for Trailer Suspension Parts
- Search Results: bronze bushings
- Shop: Trailer Wiring
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Troubleshooting Brake Controller Installations
- Search Results: 75774