Replacement Gears for etrailer.com and Ram Square A-Frame Jack TJDA-5000S

Question

Question:

Do you sell a replacement gear kit for TJD or TJDA-5000S kits? Will the kit for TJA-5000 jacks fit TJD?

asked by: Matthew C

1

Helpful Expert Reply:

I reached out to my tech contact and confirmed that the Replacement Sidewind Gear Kit for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs # TJD-7000S-GR is the same gear kit used in the Square A-Frame Jack w/ Footplate - Drop Leg - Sidewind - 15-1/4" Travel - 3,000 lbs # TJDA-5000S. I've attached videos of each to assist.

expert reply by: Jason S

1

Answer 1

To replace the ADTH 1RV-200 motor on your landing gear the Stromberg Carlson #LG-196308 will work perfectly. This motor is rated for 6,500 pounds like your existing unit. For a gear box replacement you'd want the #LG-179015.

view full answer...

Answer 2

I linked the schematic diagram for Lead Jack Repair Kit #LG-146059 taken from the written instructions. The complete instructions will be sent to you in a separate link. The follow leg repair kit is part #LC146060 in case you need it.

view full answer...

Answer 3

I went into our warehouse with a digital caliper to take the requested measurements for you. The Replacement Gear Kit for etrailer and Ram Sidewind Jacks - 2,000 lbs and 5,000 lbs #TJA-2000S-GR has an inner diameter of 0.5 inches and outer diameter…

view full answer...

Answer 4

The Lippert Components Lead Leg Repair Kit #LC146059 and the Stromberg Carlson Kit #LG-146059 referenced in your question are essentially the same kit. I went out to our warehouse to verify this. It is actually not too uncommon for landing gear…

view full answer...

Answer 5

Yes, there is 15 teeth per each gear on the Replacement Gear Kit for etrailer and Ram Sidewind Jacks #TJA-2000S-GR. These gears have a thickness of 0.5", an OD of 1.36", and an ID of 0.5".

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...