Internal Dimensions and Working Load Limit of the Curt Heavy Duty D-Ring Tie-Down Anchor # C83760

Question

Question:

What are the internal dimensions of the ring? And what is the working load limit?

asked by: Michelle T

0

Expert Reply:

The internal dimensions of the Curt Heavy Duty D-Ring Tie-Down Anchor # C83760 are 3" wide x 2-1/2" tall as you can see from the attached photo. The working load limit is 8,833 lbs.

expert reply by: Jon G

0

click to enlarge

Answer 1

The only 1/2" to 5/8" chain binders we offer have two hooks, the 13,000 lb-rated Titan Chain Ratchet Type Load Binder for 1/2" - 5/8" Thick Chain #TCRB13 and the 18,100 lb-rated Durabilt Ratchet Chain Binder for 1/2" to…

view full answer...

Answer 2

That's a good question, because working load limits (WLL) can be somewhat confusing, but I can explain it for you. The 9,200 lb WLL of the Titan Chain Ratcheting Load Binder for 3/8" - 1/2" Thick Chain #TCRB10 simply means that the…

view full answer...

Answer 3

The Buyers Products 15 Ton Pintle Hook with Mounting Kit #33710040 actually comes with the mounting hardware needed to get it installed but if you're needing to replace it you can find it with the Pintle/Combination Hitch Mounting Kit #3378520.

view full answer...

Answer 4

The Timbren Silent Ride #TSR7KS02 that you referenced was intended for attaching to a trailer frame, but could also attach to a truck frame too assuming it's a standard boxed frame. I attached a picture that shows how it typically bolts to a…

view full answer...

Answer 5

I reached out to my contact at Dutton-Lainson and confirmed there is not a way to reduce the minimum operating weight required. Both the #DL15761 and the #DL14964 use the same brake pad and washer. However, #DL15761 (2,500 lbs) is physically…

view full answer...

Answer 6

Usually loops for the safety chains are on the hitch receiver because a pintle hitch like the Buyer's Products #33710045 you referenecd often connects to a mount the B&W #BWPMHD14003 which slides into a receiver. If this isn't how yours…

view full answer...

Answer 7

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Internal Dimensions and Working Load Limit of the Curt Heavy Duty D-Ring Tie-Down Anchor # C83760

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching