Repairing Pinhole Leak on High Country Plastics 25 Gallon Water Caddy

Question

Question:

Pinhole leak in tank near lower spigot. What kind of plastic is this made of and can it be plastic weldedinch to repair the leak.

asked by: Don F

1

Helpful Expert Reply:

I spoke with my contact at High Country Plastics and she said that the Horse Trailer 25 Gallon Water Caddy # SL-25 is constructed of low linear density polyethylene. If you or somebody you know can plastic weld you should be able to repair the hole without a problem using a strip of this plastic.

expert reply by: Chris R

1

Answer 1

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 2

Yes, you'd just need to reach out to a qualified welder and have them weld on spring seats like part #TRSS300 to the top side of the Trailer Axle Beam with Easy Grease Spindles #e45GR. It's super common to do for people who have an…

view full answer...

Answer 3

Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…

view full answer...

Answer 4

There is always a way to make it work. I can't recommend doing that as I have not tested it and I do not offer a product like that with the exception of the Dexter Trailer Springs Over-Under Conversion Kit part #K71-384-00. This will give you…

view full answer...

Answer 5

It is imperative you check your local laws for lighting requirements in regards to your specific trailer, though I can tell you you no matter what you'll need stop lights, tail lights, turn signals and reflectors. There are other factors,…

view full answer...

Answer 6

You can add larger wheels and tires to a trailer as long as you have enough room for the larger size. The main clearance issues we find when putting larger tires and wheels on a trailer is from the top of the tire to the fender and from the inside…

view full answer...

Answer 7

Are the holes you are referring to threaded? If so then you could drill a 1/4" hole into one of our pads (see below) and then use a bolt to attach them to the wall. If the holes are not threaded then it may just be best to use a few…

view full answer...

Answer 8

To replace your Dexter 10-36 grease seals I recommend using Grease Seal #GS-2250DL. This seal has an inner diameter of 2.25" and outer diameter of 3.376". This is a double lip seal.

view full answer...

Answer 9

The standard 3,500 lb axle uses the Hub Bearing Kit #BK2-100 which is for a #84 spindle. If your axle is a 1990 or newer then you likely need these parts but if it's older then I'll need you to measure your spindle to make sure we can…

view full answer...

Answer 10

As you may have already found, 5200 lb, 6000 lb and 7000 lb axles can all use the same components including inner/outer bearings, hubs and brakes. Here are some other things they share in common: Dexter 5200 lb Regular Duty Axle - 0.180 inch tube…

view full answer...

Repairing Pinhole Leak on High Country Plastics 25 Gallon Water Caddy

Product Page this Question was Asked From

Continue Researching