Can the Electric Jack w/ Footplate Be Immersed in Water

Question

Question:

As long as motor head stays dry, how durable would jack be if lower part gets immersed in fresh water ?

asked by: Chuck L

1

Helpful Expert Reply:

The footplate on the Electric Jack w/ Footplate part # EJ-3520-BBX has a zinc coating which is corrosion resistant and will withstand use in fresh water but I cannot exactly recommend that you use the jack while immersed. There is also a chance for rust to form inside the outer tube which could then affect the ability of the inner leg to retract/extend over time. This will be the case for pretty much all trailer jacks. In short, they can withstand exposure to water but they are not really designed to be immersed. If you do decide to use the jack while immersed in water then make sure to keep a good coat of grease on the inner tube.

expert reply by: Conner L

1

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

Hi Tom, I have two options to replace the electric tongue jack on your Jayco Whitehawk: Option 1: Electric Jack w/ Footplate #EJ-3520-BBX. This jack is going to be your no-frills 'get the job done' style jack. It has a 3,500lb capacity and…

view full answer...

Answer 4

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.

view full answer...

Answer 5

For your electric jack, there are only three possible explanations for your jack not working with a charged battery. Either power is not getting to your motor, your motor is bad, or your ground connection isn't working properly. To test power,…

view full answer...

Answer 6

Since the Ultra-Fab Electric A-Frame Jack #UF97FR has a triangular bolt pattern it would rotate the jack 120 degrees and may or may not work for your application. There are other jacks which have multiple mounting patterns on the flange like the…

view full answer...

Answer 7

The bearing kit you need for your trailer is part #BK1-100. This will include L44643 inner and outer bearings, and the seal with a 1.249 inside diameter. The kit also includes the races and a cotter pin. If you are replacing both sides of the trailer…

view full answer...

Answer 8

This is a pretty common issue with aluminum frames so we definitely have a options available for you. With that being said, the 8 inch frame height will make things a bit more difficult, but not impossible. First, the Curt TruTrack Weight…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Can the Electric Jack w/ Footplate Be Immersed in Water

Product Page this Question was Asked From

Continue Researching