Recommended Towing Mirrors for a 2017 Honda Ridgeline

Question

Question:

Can you recommend a slip on towing mirrors for 2017 Honda Ridgeline

asked by: Frank M

0

Expert Reply:

I do have a solution for you but unfortunately there are no custom slip-on towing mirrors that will fit your 2017 Honda Ridgeline. Instead I recommend using the K-Source Universal Dual Lens Towing Mirrors # KS3990 because of the wide variety of mirrors they fit. These will fit most 4-1/2" to 11-1/2" tall mirrors and they come with a limited 90-Day warranty.

Attached is a review video for you to check out.

expert reply by: Jon G

0

Answer 1

I have a great towing mirror solution for you. Unfortunately, the CIPA Custom Towing Mirrors #CM11400 do not fit your factory mirrors on your 2019 Honda Ridgeline. However, we do have a great set of mirrors that do fit. For that route, I recommend…

view full answer...

Answer 2

For your 2021 Honda Ridgeline I recommend the K-Source Universal Dual Lens Towing Mirrors - Clip On - Pair Item #KS3990 as it is held onto the mirror with ratchet straps that can easily adjust to your mirrors. The Honda Ridgeline uses the same…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...