Can Firestone Ride Rite Kit # F2407 Fit 2007 Toyota Tacoma with 2 inch Lift

Question

Question:

Hi There My 2007 Tacoma was made 2inch Hi-lift kit , can i install this kit ?

asked by: Tomjo

0

Expert Reply:

Firestone sells a 2 inch lift spacer part # F2366 for vehicles like yours that have a 2 inch lift. This can be used with the Firestone Ride Rite kit part # F2407 for your 2007 Toyota Tacoma that you referenced as well.

expert reply by: Jameson C

0

Answer 1

There are different ways to lift a vehicle so that could be one factor, Also, it isn't really a measurement so much as it is based on what the amount of lift is supposed to be. You would measure, though, with the truck on the ground and not…

view full answer...

Answer 2

When measuring the gap for Firestone air bag kit install to determine if spacers like the part #F2366 are needed the measurement should be taken with the vehicle on level ground.

view full answer...

Answer 3

I would recommend you get the appropriate lift spacer on your 2004 Toyota Tundra with the Firestone Ride Rite System part #F2245 installed. If you have a 2 inch lift you would want the #F2366 that you referenced. If you are using the #F2245 to raise…

view full answer...

Answer 4

According to Firestone, the Firestone Ride-Rite Air Helper Springs #F2407 are fine to be lifted on a hoist or for a short term service work. However, if the vehicle will be on the hoist for a prolonged period of time, you should support the axles…

view full answer...

Answer 5

Yes, the Firestone Ride-Rite Air Helper Springs part #F2407 will work on a 2017 Toyota Tacoma so long as the axle is below the leaf springs. That said, you'd also need the Firestone Axle Bracket Extension Kit for Lifted Vehicles part #F2506 to…

view full answer...

Answer 6

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 9

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

For all intents and purposes, yes, the Fulton drop leg stabilizer jack SJL80300 is the same as the square leg jack you asked about: - Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs #SJ-R208 Different manufacturers but otherwise they…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Can Firestone Ride Rite Kit # F2407 Fit 2007 Toyota Tacoma with 2 inch Lift

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching