Replacement Landing Gear Leg for 2008 Keystone Raptor 3815TS Toy Hauler

Question

Question:

Will this unit fit my 2008 Raptor 3815TS toy hauler? Lead jack works find along with bar in middle. Left driverside jack does not move, up or down.

asked by: Timothy L

0

Expert Reply:

It sounds like your 2008 Raptor 3815TS Toy Hauler lead jack and motor work fine but there is an internal issue on the follow jack. From previous customers I know the Raptor has 17-1/2 inches spacing between the weld stops on the legs. If you just want to replace that follow leg, I recommend the Replacement Follow Leg for Keystone Montana 5th Wheel Landing Gear # LC178652.

If you choose to upgrade to individual motors, I recommend the Reese Electric 5th Wheel Landing Gear Set - 36" Lift - 8,000 lbs # RP500708 which come with drop legs and the switches for independent function for easy leveling.

expert reply by: Jason S

0

click to enlarge

Answer 1

For your Venture landing gear you can use #LC276602 or #LG-179015. Either one will work.

view full answer...

Answer 2

The gearbox #RVLG-RDBOX for the Landing Gear Set w/ Handle #RVLG-8HDL can be mounted in the horizontal or vertical position. I went out to the warehouse and tested both the gearbox and lead leg together and the pins that hold the gearbox in place…

view full answer...

Answer 3

The correct landing gear set for your 2011 Keystone RV Cougar Fifth Wheel Series M-244 RLS should be the Lippert Electric Landing Gear Set part #LC333964. In order to make sure you will want to take a quick measurements from the outside edge of each…

view full answer...

Answer 4

For your 2008 Keystone Challenger with the Venture 940RB landing gear motor you can replace the gear box with either #LC276602 or #LG-179015. Either one will work but the Lippert one is has a plastic casing where the Stromberg Carlson gear box has an…

view full answer...

Answer 5

We have spoke with our contacts at Lippert/Venture about greasing their landing gear legs that have zerk fittings and they recommended a white lithium grease like #L11354 for the zerk fitting for the gears and a silicone based lubricant on the…

view full answer...

Answer 6

In order to find the correct set of landing gear legs for a trailer you need to measure the distance between the weld stops on the legs. The most common is 15-1/2" and likely what you have now and if that's the case you can use the Lippert…

view full answer...

Answer 7

I believe the Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear #LG-179015 is what you are looking for. This is a replacement for several different manufacturers. Be sure to compare this with the one that you have on your 2006 Keystone…

view full answer...

Answer 8

This Stromberg-Carlson Motor and Switch Kit, part # LG-217884, is compatible with most brands of landing gear, including Lippert and Atwood. I spoke to my contact at Lippert, who manufactures the motor, and they confirmed that most landing gear that…

view full answer...

Answer 9

To upgrade a single motor Stromberg Carlson landing gear set to dual motors, you would need a replacement lead leg, #LG-179013 (the two legs would not be attached to each other in a dual motor set up), a gear box, #LG-179015, and the motor,…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...