Is the Yakima OffGrid Accessory Crossbar End Piece Plastic or Metal?

Question

Question:

Y07353--Are the end pieces plastic?

asked by: Dwan K

0

Expert Reply:

The Accessory Bar for 40" Wide Yakima OffGrid Roof Cargo Basket # Y07353 has a piece of the assembly that is a composite plastic, however the part that actually attaches to the bottom of the bar is metal as is that adjustment screw.

expert reply by: Jason S

0

click to enlarge

Answer 1

Have you tried adjusting the load bar? If you could email me a photo of the issue that may also help me figure out what the issue is.

view full answer...

Answer 2

For the Yakima LoadWarrior cargo baskets like the #Y07070 the correct load bar is the part #8870042.

view full answer...

Answer 3

The tubing that the Yakima LoadWarrior Cargo Basket is constructed of also has a 1 inch diameter. The top tubes of the LoadWarrior are 38-1/2 inches apart, if the sides of your basket are closer than that, you'd need to shorten the load bar.

view full answer...

Answer 4

The Yakima Accessory Bar #Y07353 that you referenced is designed specifically for certain model Yakima baskets and unfortunately isn't the right size to fit your Thule model #TH859XT. There is not a similar support bar available for this…

view full answer...

Answer 5

Both the Yakima OffGrid #Y07138 and the Thule Canyon XT #TH859XT roof baskets are compatible with round, square, aero, elliptical, and most factory crossbars and both feature comparable weight capacities: 165 lbs for the OffGrid and 150 lbs for the…

view full answer...

Answer 6

That's a good question, so I checked directly with Yakima for you, and the medium OffGrid cargo basket does indeed fit your 2019 Toyota Tacoma with the factory roof rack, so long as you get the 18 inch extension for it. So here is exactly what…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Is the Yakima OffGrid Accessory Crossbar End Piece Plastic or Metal?

Product Page this Question was Asked From

Continue Researching