Do TrailerLegs Tire Saver Stands # 326-TRLLG-4 Require Pavement to be Used

Question

Question:

TrailerLegs Tire Saver Stands - all of the pictures and videos show these being used on paved areas. Do they work in gravel or grass/dirt. I realize they need a base that will support the weight but wondered if the stand would even be able to get a bite and rotate or would just slide over the ground.

asked by: Brent S

0

Expert Reply:

As long as the ground is level and stable (meaning not mud or anything else you may sink into) the TrailerLegs Tire Saver Stands # 326-TRLLG-4 can be used and they'd work fine.

expert reply by: Jameson C

0

Answer 1

The TrailerLegs Tire Saver Stands for Trailers w/ Leaf Spring Suspensions part #326-TRLLG-4 are designed from a very dense polyethylene material that while very strong it is not as strong as steel. This means if any thing were to bend or deform it…

view full answer...

Answer 2

I have just what you need for saving your 5th wheel trailer tires from getting flat spots, the TrailerLegs Tire Saver Stands. Kit #326-TRLLG-4 for tandem axles and kit #326-TRLLG-6 for triple axle trailers allow you to lift your trailer up off the…

view full answer...

Answer 3

Yes, there are anti-rattle devices that can be used with the Equal-i-zer Weight Distribution System to prevent the shank from sliding back and forth and damaging the hitch pin hole. The Equal-i-zer System has a solid shank which means the only type…

view full answer...

Answer 4

The TrailerLegs Tire Saver Stands #326-TRLLG-4 are perfectly safe for your axles and will not cause any damage whatsoever. Axles are designed to bear the weight of a trailer and using the TrailerLegs does not affect their capacity or ability to do…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...