How to Upgrade from the Lippert Ground Control 2.0 to the Lippert Ground Control 3.0 Leveling System
Question:
Do you know if Lippert is going to possibly make a conversion kit to go from a 2.0 to a 3.0? Is it possible for the rear jacks of the 3.0 system to bolt up on the current brackets of the 2.0 system welded on the frame?
asked by: Bobby
Expert Reply:
There is no conversion kit from the Lippert Ground Control 2.0 Leveling System to the Lippert Ground Control 3.0 Leveling System nor am I aware of Lipperts plans to design one. However, you should not have any problems replacing the old system with the new. It will however be a complete replacement as none of the parts carry over. The rear mounting brackets you have now will need to be cut off and the new ones will need to be welded on. The wiring harness and control module will also need to be swapped out as well. The front mounting brackets however will not change.
If the gross vehicle weight rating (GVWR) of your trailer is less than 15,500 lbs and the distance between the center of the front landing gear foot and center of the rear landing gear jack foot will be less than 20' then you will want to use the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC358590 (4-Point). If the above distance between the center of the front landing gear foot and center of the rear landing gear jack foot will be 20' or greater then you will want to use the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC675817 (6-Point).
Products Referenced in This Question
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: touch pad
- Shop: Replacement Lippert Touchpad for Kwikee Level Best Hydraulic Leveling System - Winnebago
- Shop: Replacement Operator, Knob and Screw for Ventline Ventadome Trailer Roof Vents w/ Wedge-Shaped Dome
- Shop: Lippert Replacement 500:1 Motor for Electric In-Wall RV Slide-Out System - High Torque
- Shop: Replacement Lippert Control Panel with Amp Connector for 4-Point Leveling System
- Shop: Replacement Control Module for Lippert Ground Control 2.0 Electric Leveling System
- Q&A: What Type of Fluid to Use in Lippert Hydraulic Leveling Systems
- Shop: Replacement 22-1/2" Right Rear Leg for Lippert Ground Control 3.0 Electric Leveling System
- Shop: Replacement 24-1/2" Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System
- Q&A: Can Lippert Ground Control 2.0 be Upgraded to 3.0 Without Buying New System
- Q&A: Troubleshooting Middle Jacks Of Lippert Ground Control 2.0 System Not Retracting After Battery Died
- Q&A: Troubleshooting Middle Jacks Not Grounding On Lippert Ground Control 2.0 Leveling System
- Search Results: sp54~180
- Search Results: trailer jack
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Most Popular Wheel Bearings
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: lug nut
- Shop: Trailer Wiring
- Q&A: Replacement Drum Brake Actuator for a 1995 4 Winns Model 3916 Trailer
- Shop: Suspension Enhancement
- Search Results: fender
- Video: Choosing the Right Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Shop: Brake Controller
- Search Results: safety chains
- Shop: Fifth Wheel Hitch
on Camper Jacks
