Will Go Power Heavy-Duty Modified Sine Wave Inverter # 34280175 Charge Phone Battery and Power Fan

Question

Question:

Im wanting to power an inverter off of a single 12 marine style battery in my 10 foot cargo trailer that Ive converted into a small camper. I plan to only power a small room fan and charge cell phone overnight. Will this inverter do the trick with a single 12V marine battery? If not what size inverter and battery setup would I need? Also, do I need to ground the inverter to the trailer and add a fuse between the battery and inverter?

asked by: Jim

0

Expert Reply:

Yes, the Go Power Heavy-Duty Modified Sine Wave Inverter # 34280175 would work great to power your small fan and charge your cell phone when connected to your 12 volt marine battery. This would need to connect to the positive and ground of your battery but it would not require you to use any additional circuit protection.

expert reply by: Jameson C

0

Answer 1

The Installation Kit for Go Power 12V or 24V Inverters #342GPDCKIT2 has a T-fuse that is needed because it serves as protection for the connection made between the battery and 12V Inverters #34280175, #34280176 and #34279948 as well as 24V Inverter…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 8

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Will Go Power Heavy-Duty Modified Sine Wave Inverter # 34280175 Charge Phone Battery and Power Fan

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching