Brake Installation Hardware and Torque Required for 10-Inch Drum Brakes
Question:
What size are the nuts and washers needed to hold the brake assembly to the axle plate?
asked by: David R
0
Expert Reply:
Electric drum brakes such as # AKEBRK-35L-SA will use nut/lock washer hardware kit # BRKH10BS and the nuts should be tightened to 45 to 50-ft-lbs. If you need a torque wrench we offer several such as # ALL644044 as well as Torque Adapter # PTM206 which fits any 1/2-inch ratchet.
expert reply by:
Adam R
0
click to enlarge
Products Referenced in This Question
Powerbuilt Beam-Type Torque Wrench - 1/2" Drive - 0 to 140 ft-lb
- Automotive Tools
- Wrenches
- Torque Wrench
- 140 ft/lbs
- 1/2 Inch Drive
- Powerbuilt
more information >
Mounting Hardware for 10" Single Brake Assembly
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- Hydraulic Drum Brakes
- Hardware
- 10 Inch
- Redline
more information >
Product Page this Question was Asked From
Electric Trailer Brake Assembly - Self-Adjusting - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Self Adjust
- 10 x 2-1/4 Inch Drum
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Choose Correct Replacement Bearings and Seal
- Q&A: Replacement Grease Seals For Trailer With 3,500 Lb Axle
- Q&A: Can I Use Dexter Components on Lippert Axles and Vice Versa?
- Q&A: Would Titan Breakaway and Parking Kit # T2385200 Work on Sloan Kwik Load Trailer
- Q&A: Electric Trailer Brake Magnet Short Circuit Indicator on Brake Controller Comes On After Moving
- Q&A: Is It Required The Spring Seat Be Welded to Trailer Axle
- Q&A: Looking For Replacement Trailer Axles With 70 Inch Spring Center and 85 Inch Hub Face Spacing