Replacement Motor for 42 Series Kwikee Electric Step

Question

Question:

I need the replacement motor for the above coach. I have the series 42 steps.

asked by: Jimmie

1

Helpful Expert Reply:

The correct replacement motor for your 42 Series Kwikee Electric Step is the Lippert Components Kwikee Step Motor part # LC369506. The 25 Series and 42 Series use the same motor which is why this particular motor is listed for a 25 Series but it will work on your 42 Series as well.

expert reply by: Conner L

1

Answer 1

As you have been hearing a grinding noise on the Kwikee steps on your 2019 Tiffan Open Road Allegro, I would check the Gear Box and A Linkage #LC379160. If you remove the gear box you will be able to actuate the arm and determine if you feel any…

view full answer...

Answer 2

I have included the correct replacement parts for your 2012 Tiffin Open Road with Kwikee Series 41 steps below. - Replacement Motor for Kwikee Electric RV Steps #LC379147 - Replacement Gear Box and A Linkage for Kwikee Electric RV Steps #LC379160 -…

view full answer...

Answer 3

It sounds like you know exactly what you need. I can confirm you are correct the Replacement Control Unit for Kwikee Electric RV Steps item #LC379146 is the correct part for the Kwikee Series 42 powered steps that were made before 2005.

view full answer...

Answer 4

Since you need the Replacement Control Unit for Kwikee 38 Series Electric RV Steps #LC363989 I'm assuming you have 38 series steps on your 2017 Thor Windsport. The correct replacement motor for these steps would be the #LC379147.

view full answer...

Answer 5

From the picture you provided it appears you have the Lippert Kwikee 42 Series Double Tread Electric Step #LC372779. Unfortunately, we don't have replacement parts for the steps. Before purchasing make sure the mounting bolt pattern matches.…

view full answer...

Answer 6

To find the fuse for your Kwikee Electric RV Step Complete Assembly #LC3658373 you'll need to trace the power wire from the switch to the battery. If you think you've found it then you can test continuity of the fuse and replace if necessary.…

view full answer...

Answer 7

Thank you for the pictures- they're always helpful! I have a solution for you, but the Lippert gear box you were looking at is a replacement for the newer Kwikee 32 Series Steps. I spoke with my contact at Lippert and they said that the gearbox…

view full answer...

Answer 8

Yes, anytime you use a hitch extender or reducer like #HR26 you will lose about 1/3 of your hitches overall capacity. However, since you'll be towing a trailer that weighs between 4,500 to 5,000 lbs, the Brophy Hitch Reducer #HR26 will still work…

view full answer...

Answer 9

There are indeed many different replacement step controllers out there and I am happy to re-confirm that the correct current item to replace your Kwikee step controller 1800709 is part #LC363989. I verified this item with my parts contacts at…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replacement Motor for 42 Series Kwikee Electric Step

Product Page this Question was Asked From

Continue Researching