Opening Dimensions of DeeZee Specialty Series Underbody Toolbox # DZ61

Question

Question:

Im wondering what the dimensions of the opening are? Wondering if I can put my Honda EU2000 in it

asked by: Brian M

1

Helpful Expert Reply:

The opening of the DeeZee Toolbox # DZ61 that you referenced is 23 inches wide by 17 inches tall.

expert reply by: Jameson C

1

click to enlarge

Answer 1

I have a solution but all dual hitch adapters are only rated for flat towing. To tow a trailer and haul a bike rack off of your vehicles hitch, I recommend the Gen-Y Adjustable 2-Ball Mount w/ Stacked Receivers item #325-GH-514. This adjustable ball…

view full answer...

Answer 2

The dimensions for the RC Manufacturing Trailer Tongue Box are; width at back is 36 inches, width at front is 21-1/2 inches, the height of the box is 20 inches and the depth of the box is 16 inches. You can see these dimensions in the photo I have…

view full answer...

Answer 3

I recommend starting off by measuring to see exactly how large of a toolbox that you will need. I have included a link to all of our A-frame toolboxes for you to take a look at. Two of our largest boxes are the DeeZee Specialty Series Trailer Tongue…

view full answer...

Answer 4

The DeeZee Specialty Series Trailer Tongue Toolbox, #DZ91717P, is 36 inches wide at the back of the box. I have attached a picture showing the dimensions of this box for you. You mention the specs showing 30 inches but I am not sure where that…

view full answer...

Answer 5

For a single replacement Pin Lock you will need part #TL11001. It is a direct replacement for your pin lock with the key P01. My contact at TorkLift verified that all of them are keyed alike so you will not have to give any specific part numbers when…

view full answer...

Answer 6

For a single replacement pin lock for the Torklift Fastguns we have the part #TL11001 which would be what you would need. The #TLA7509 doesn't have a wide enough usable span to work with the FastGuns #TLS9522-2-LK.

view full answer...

Answer 7

If it were my trailer I would fasten the E-Track to the support beams under the trailer, either the side to side one or front to back ones, by going all the way through those support beams. E-Track like #E19148 is zinc-coated steel and since the…

view full answer...

Opening Dimensions of DeeZee Specialty Series Underbody Toolbox # DZ61

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching