Inside and Outside Dimensions of etrailer Cargo Carrier # e98874 Measured in Inches

Question

Question:

Are the measurements for the carrier the inside or outside measurements?

asked by: Shawn S

0

Expert Reply:

The 24x60 etrailer Cargo Carrier for 2" Hitches - Steel - Folding - 500 lbs # e98874 has an outside dimension of 61-1/2" wide x 25-3/4" deep x 6-1/2" tall and an inside dimension of 60" wide x 24" deep x 5-1/2" tall.

expert reply by: Jason S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

The best hitch for a 2024 Subaru Outback is the etrailer item #e25TR. This hitch is custom fit and bolts to your Subaru with included hardware. This is a class III hitch with a 2" receiver, that has a 3,500 lbs towing capacity and a 350 lbs…

view full answer...

Answer 3

I measured the distance of the hitch pin hole to the front of the Curt Cargo Carrier for 2" Hitches #C18113 and found it was 29 inches from the center of the hitch pin hole to the furthest part (the front) of the carrier, as you can see in the…

view full answer...

Answer 4

I have a set that will work however your 2023 Chevy Suburban's owners manual says not to use tire chains because of clearance issues on the inner part of the tires. You can find this information on page 370. To avoid damaging brake lines and…

view full answer...

Answer 5

The Curt Cargo Carrier #C18113 will definitely work with the etrailer #e25TR on your 2024 Outback. Keep in mind, you will be limited to the 350 lb max tongue weight of the hitch or the max tongue weight of your vehicle. Whichever is lower is what you…

view full answer...

Answer 6

Any type of hitch adapter or extender will have the unavoidable side-effect of causing a loss of about half of your hitch's rated capacity, both its tongue weight (TW) and it's gross towing weight (GTW). Hidden Hitch extender #HE18 and Curt…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

From the center of the hitch pin hole to the upright portion of the Saris swinging hitch adapter #SAR36VR the measurement is 9 inches so this would easily clear past your spare since it is 7-3/4 inches out past the rear hitch pin.

view full answer...

Answer 9

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...